background image
Order No. MD0008135C2
AV Control Stereo Receiver
SA-DA8
Color
(K) ... Black Type
(N) ... Gold Type
E ... Europe
EB ... Great Britain
EG ... Germany and Italy
SPECIFICATIONS
1


background image
FM Tuner Section
Frequency range
87.9-107.9 MHz
Sensitivity
11.2 dBf (2
V, IHF'58)
50 dB quieting sensitivity
MONO
18.3 dBf (4.5
V, IHF'58)
STEREO
38.3 dBf (45
V, IHF'58)
Total harmonic distortion
MONO
0.2%
STEREO
0.3%
S/N
MONO
73 dB
STEREO
67 dB
Frequency response
20 Hz-15 kHz, +1 dB, -2 dB
Alternate channel selectivity
65 dB
Capture ratio
1.5 dB
Image rejection at 98 MHz
40 dB
Spurious response rejection at 98 MHz
75 dB
AM suppression
50 dB
Stereo separation
1 kHz
40 dB
10 kHz
30 dB
Antenna terminal
75
(unbalanced)
AM Tuner Section
Frequency range
530-1710 kHz
Sensitivity
20
V, 330
V/m
Selectivity
55 dB
IF rejection (at 1000 kHz)
50 dB
Video Section
Output voltage at 1 V input
(unbalanced)
1±0.1 Vp-p
Maximum input voltage
1.5 Vp-p
Input/output impedance
75
Amplifier Section
Rated minimum sine wave RMS power output
20 Hz-20 kHz both channels driven
0.09% total harmonic distortion
100 W per channel (6
)
1 kHz continuous power output both channels driven
0.05% total harmonic distortion
105 W per channel (6
)
Total harmonic distortion
rated power at 20 Hz-20 kHz
0.09% (6
)
half power at 1 kHz
0.03% (6
)
Power bandwidth
both channels driven, -3 dB
10 Hz-70 kHz (6
, 0.9%)
Power output at the DVD 6CH operation
20 Hz-20 kHz (each channels driven)
0.09% total harmonic distortion
Front
2 x 100 W (6
)
Center
100 W (6
)
2


background image
Center
100 W (6
)
Surround
2 x 100 W (6
)
Low frequency damping factor
30 (6
)
Load impedance
Front
A or B
4 - 8
A and B
8
BI-WIRE
6 - 8
Center
6 - 8
Surround
6 - 8
Frequency response
PHONO
RIAA standard curve ±0.8 dB
CD, DVD, TV, VCR1, VCR2, VCR3,
TAPE
10 Hz-100 kHz, ±3 dB
Input sensitivity
PHONO
0.4 mV (3 mV, IHF'66)
CD, DVD, TV, VCR1, VCR2, VCR3,
TAPE
27 mV (200 mV, IHF'66)
S/N (IHF A) (VGCA ON)
PHONO
80 dB (80 dB, IHF'66)
CD, DVD, TV, VCR1, VCR2, VCR3,
TAPE
113 dB (IHF A, Rated Power,
S=2 V)
90 dB (100 dB, IHF'66)
Input impedance
PHONO
47 k
CD, DVD, TV, VCR1, VCR2,
VCR3,TAPE
22 k
Tone controls
BASS
50 Hz, +10 to -10 dB
TREBLE
20 kHz, +10 to -10 dB
Subwoofer frequency response (-6 dB)
7 - 200 Hz
Digital input (OPTICAL)
CD, DVD, TV
General
Power supply
AC 120 V, 60 Hz
Power consumption
310 W
Dimensions (W x H x D)
430 x 158 x 370 mm
(16-15/16" x 6-7/32" x 14-9/16")
Mass
11.7 kg (25.8 lb.)
Power consumption in standby mode:
1 W
DIN POWER (1 kHz T.H.D. 1%)
2 X 100W (6
)
Notes:
1. Specifications are subject to change without notice. / Mass and
dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum analyzer.
* Manufactured under license from Dolby Laboratories. "Dolby",
"Pro Logic" and the double-D simbol are trademarks of Dolby
Laboratories.
** Manufactured under license from Digital Theater System. "DTS"
and "DTS Digital Surround" are trademarks of Digital Theater
Syatem.


background image
1. Before Repair and Adjustment
Disconnect AC power, discharge Power Supply Capacitors C1702 through a 10
, 5 W resistor
to ground. DO NOT SHORT-CIRCUIT DIRECTLY (with a screw driver blade, for instance), as this
may destroy solid state devices.
After repairs are completed, restore power gradually using a variac, to avoid over current.
Current consumption at AC 120 V, 60 Hz in NO SIGNAL mode should be 750~1050 mA.
2. Protection Circuitry
The protection circuitry may have operated if either of the following conditions are noticed:
- No sound is heard when the power is turned on.
- Stops during a performance.
The function of this circuitry is to prevent circuitry damage if, for example, the positive and
negative speaker connection wires are "shorted", or if speaker systems with an impedance less
than the indicated rated impedance of the amplifier are used.
If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note:
When the protection circuitry functions, the unit will not operate unless the power is first turned
off and then on again.
3. Accessories
AC power supply cord... 1 pc.
AM Loop Antenna Set / ... 1 set.
4


background image
FM Indoor Antenna... 1 pc.
Remote Control / Transmitter... 1 pc.
4. Caution for AC Mains Lead
5