This appliance has a serial number located on the rear panel. Please record
the model number and serial number and retain them for your records.
3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan Phone: (0422) 52-5081
TEAC AMERICA, INC.
7733 Telegraph Road, Montebello, California 90640 Phone: (323) 726-0303
TEAC CANADA LTD.
5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada Phone: (905) 890-8008
TEAC MEXICO, S.A. De C.V
Campesinos N°184, Colonia Granjas Esmeralda, Delegacion Iztapalapa, CP 09810, México DF
Phone: (525) 581-5500
TEAC UK LIMITED
Unit 19 & 20, The Courtyards, Hatters Lane, Watford, Hertfordshire, WD18 8TE, U.K.
Phone: (0845) 130-2511
TEAC EUROPE GmbH
Bahnstrasse 12, 65205 Wiesbaden-Erbenheim, Germany Phone: 0611-71580
TEAC ITALIANA S.p.A.
Via C. Cantù 9/A, 20092 Cinisello Balsamo, Milano, Italy Phone: 02-66010500
TEAC AUSTRALIA PTY., LTD.
30 Tullamarine Park Road, Tullamarine, VIC 3043, Australia Phone: (03) 8336-6500
A.B.N. 11 113 998 048
Hi-Fi Table Radio
Includes adapters for:
iPod with Click Wheel
iPod with color display
Adapters sold separately:
iPod with dock connector
Adapters included with iPod:
iPod with video
DO NOT REMOVE THE EXTERNAL CASES
ELECTRONICS. NO USER SERVICEABLE
PARTS ARE WITHIN!
IF YOU ARE EXPERIENCING PROBLEMS
WITH THIS PRODUCT, CONTACT TEAC
FOR A SERVICE REFERRAL. DO NOT USE
THE PRODUCT UNTIL IT HAS BEEN
WARNING: TO PREVENT FIRE
OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are
protection against harmful interference in
a residential installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
· Reorient or relocate the equipment
and/or the receiving antenna.
· Increase the separation between the
equipment and receiver.
· Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
· Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this
equipments not expressly approved by
TEAC CORPORATION for compliance will
void the user's warranty.
The apparatus draws nominal non-
operating power from the AC outlet
with its STANDBY/ON switch in the
The apparatus should be located close
enough to the AC outlet so that you can
easily grasp the power cord plug at any
An apparatus with Class ! construction
shall be connected to an AC outlet with
a protective grounding connection.
AC POWER CORD CONNECTION
TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT,
CORDE DE CONNEXION CA
POUR ÉVITER LES CHOCS ÉLECTRIQUES,
INTRODUIRE LA LAME LA PLUS LARGE
CORRESPONDANTE DE LA PRISE ET
POUSSER JUSQU'AU FOND.
Pour le CANADA
9) Do not defeat the safety purpose of the
polarized or grounding-type plug. A
polarized plug has two blades with one
wider than the other. A grounding type
plug has two blades and a third
grounding prong. The wide blade or the
third prong are provided for your safety.
If the provided plug does not fit into
your outlet, consult an electrician for
replacement of the obsolete outlet.
10) Protect the power cord from being
walked on or pinched particularly at
plugs, convenience receptacles, and the
point where they exit from the
11) Only use attachments/accessories
specified by the manufacturer.
12) Use only with the cart, stand,
tripod, bracket, or table
specified by the manufacturer,
or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination
to avoid injury from tip-over.
13) Unplug this apparatus during lightning
storms or when unused for long periods
14) Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus,
the apparatus has been exposed to rain
or moisture, does not operate normally,
or has been dropped.
Do not expose this apparatus to dripps
Do not place any objects filled with
liquids, such as vases, on the apparatus.
Do not install this apparatus in a
confined space such as a book case or
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
arrowhead symbol, within an
equilateral triangle, is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings.
8) Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers)
that produce heat.
The provided Remote Control Unit allows
the unit to be operated from a distance.
When operating the remote control unit,
point it towards the remote sensor on the
front panel of the unit.
Even if the remote control unit is
operated within the effective range,
remote control operation may be
impossible if there are any obstacles
between the unit and the remote control.
If the remote control unit is operated near
other products which generate infrared
rays, or if other remote control devices
using infrared rays are used near the unit,
it may operate incorrectly. Conversely, the
other products may also operate
1. Remove the battery compartment cover.
2. Put in the lithium battery (CR2032, 3V).
3. Close the cover.
If the distance required between the
remote control unit and main unit
decreases, the battery is exhausted. In this
case, replace the battery with a new one.
Precautions concerning batteries
Do not heat or disassemble batteries and
never dispose of old batteries by throwing
them in a fire.
Remote Control Unit
Read this before attempting any
As the unit may become warm during
operation, always leave sufficient space
around the unit for ventilation.
The voltage supplied to the unit should
match the voltage as printed on the rear
panel. If you are in any doubt regarding
this matter, consult an electrician.
Choose the installation location of your
unit carefully. Avoid placing it in direct
sunlight or close to a source of heat. Also
avoid locations subject to vibrations and
excessive dust, heat, cold or moisture.
Do not open the cabinet as this might
result in damage to the circuitry or
electrical shock. If a foreign object should
get into the unit, contact your dealer or
When removing the power plug from the
wall outlet, always pull directly on the
plug, never yank the cord.
Do not attempt to clean the unit with
chemical solvents as this might damage
the finish. Use a clean, dry cloth.
Keep this manual in a safe place for
Before Using the Unit
Ensure this product is not exposed to
dripping or splashing and that no object
filled with liquids, such as vases, is placed
on the product.
Do not install this equipment in a
confined space such as a book case or
similar unit. Allow adequate air circulation
around this product.
Thank you for choosing TEAC. Read this
manual carefully to get the best
performance from this unit.
Before Using the Unit . . . . . . . . . . . . . . . . 4
Remote Control Unit. . . . . . . . . . . . . . . . . 5
Connections . . . . . . . . . . . . . . . . . . . . . . . 6
Unit Functions. . . . . . . . . . . . . . . . . . . . . . 8
Display . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Getting Started . . . . . . . . . . . . . . . . . . . . 10
Setting the Clock . . . . . . . . . . . . . . . . . . 12
Basic Operation. . . . . . . . . . . . . . . . . . . . 13
Listening to iPod . . . . . . . . . . . . . . . . . . . 15
Listening to an External Source . . . . . . . . 17
Listening to the Radio . . . . . . . . . . . . . . . 18
Preset Tuning . . . . . . . . . . . . . . . . . . . . . 19
Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Troubleshooting . . . . . . . . . . . . . . . . . . . 22
Specifications . . . . . . . . . . . . . . . . . . . . . 23
While in FM mode, tune in an FM
station and extend the lead to find the
best position for the reception. This
antenna may need to be repositioned if
you move your unit to a new location.
AM loop antenna
Connect the supplied AM loop antenna
to the AM ANTENNA terminal.
Place the antenna on a shelf or hang it
on a window frame, etc., in the
direction which gives the best
If you want, you can hook the AM
antenna on a wall as shown below:
For private listening, insert the
headphones plug into this jack, and
adjust the volume using the VOLUME
DST (Daylight Saving Time)
Select ON to put the clock one hour
ahead. Select OFF to turn the DST off.
AC Power Cord
Plug this AC power cord into an AC
Be sure to connect the power cord to
an AC outlet which supplies the correct
Hold the power plug when plugging or
unplugging the power cord. Never pull
or yank on the power cord.
You can connect a portable audio
player to this jack.
See page 17 for details.
(front panel of the GR-10i)
Switch off the power before making connections.
Read the instructions of each component you intend to use with this unit.
Be sure to insert each plug securely. To prevent hum and noise, do not bundle the
When a component is connected to the
AUX IN jack, use this button to listen to
the external source.
Use this button to set sleep timer.
Before use, insert an appropriate Dock
adapter in the Dock (see page 10).
Insert an iPod mobile digital device into
Use this button to dim the display.
Use this button to start or pause
playback of iPod.
Use this button to set a timer.
Use this button to turn on or off the
Hold down this button for more than 3
seconds to enter clock setting mode.
Then adjust the clock using the MULTI
JOG rotary knob.
Turn this rotary knob to adjust time,
change timer setting, etc.
In TUNER mode, turn this rotary knob to
tune in stations.
Slot for the remote control unit
Keep the remote control unit in this slot
when not in use.
Use this button to mute the sound.
In TUNER mode, use this button to preset
In TUNER mode, use this button to select
a preset station.
In TUNER mode, use this button to tune
In iPod mode, use this button to skip
tracks. Hold down this button to search
for a part of a track.
To simplify explanations, instructions in
this manual refer to the names of the
buttons and controls on the front panel
only. Associated controls on the remote
control will also operate similarly.
Turn the rotary knob (or press the
VOLUME buttons of the remote control
unit) to adjust the volume level.
Use this button to turn the unit on or
Use this button to select iPod mode.
Use this button to select TUNER mode.
In TUNER mode, press this button to
select FM or AM.
The equipment draws a nominal
amount of power from the AC outlet
even with its STANDBY/ON switch in the