background image
OWNER'S MANUAL
CD-01 U /CD-01UPro
CD PLAYER
D00864010A
»


background image
O
Important Safety Precautions
2 TASCAM CD-01U/CD-01UPro
The exclamation point within an equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
The lightning flash with arrowhead symbol, within equilateral triangle, is intended to
alert the user to the presence of uninsulated "dangerous voltage" within the prod-
uct's enclosure that may be of sufficient magnitude to constitute a risk of electric
shock to persons.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
This appliance has a serial number locat-
ed on the rear panel. Please record the
model number and serial number and
retain them for your records.
Model number
Serial number
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
TO THE USER
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruc-
tion manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case the
user will be required to correct the interference at his
own expense.
CAUTION
Changes or modifications to this equipment not
expressly approved by TEAC CORPORATION for
compliance could void the user's authority to operate
this equipment.
For the customers in Europe
WARNING
This is a Class A product. In a domestic environment,
this product may cause radio interference in which
case the user may be required to take adequate
measures.
Pour les utilisateurs en Europe
AVERTISSEMENT
Il s'agit d'un produit de Classe A. Dans un environ-
nement domestique, cet appareil peut provoquer des
interférences radio, dans ce cas l'utilisateur peut être
amené à prendre des mesures appropriées.
Für Kunden in Europa
Warnung
Dies ist eine Einrichtung, welche die Funk-Entstörung
nach Klasse A besitzt. Diese Einrichtung kann im
Wohnbereich Funkstörungen versursachen; in diesem
Fall
kann
vom
Betrieber
verlang
werden,
angemessene Maßnahmen durchzuführen und dafür
aufzukommen.
For U.S.A.
CE Marking Information
a) Applicable electromagnetic environment: E4
b) Peak inrush current: 5.2 A


background image
O
Important Safety Instructions
TASCAM CD-01U/CD-01UPro
3
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near water.
6 Clean only with dry cloth.
7 Do not block any ventilation openings. Install in accor-
dance with the manufacturer's instructions.
8 Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9 Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10 Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11 Only use attachments/accessories specified by the
manufacturer.
12 Use only with the cart, stand, tripod, bracket, or table
specified by the manufacturer, or sold with the appara-
tus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-
over.
13 Unplug this apparatus during lightning storms or when
unused for long periods of time.
14 Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally,
or has been dropped.
· Do not expose this apparatus to drips or splashes.
·Do not place any objects filled with liquids, such as
vases, on the apparatus.
· Do not install this apparatus in a confined space such as
a book case or similar unit.
· The apparatus draws nominal non-operating power from
the AC outlet with its POWER switch in the off position.
· The apparatus should be located close enough to the AC
outlet so that you can easily grasp the power cord plug at
any time.
· An apparatus with Class I construction shall be connect-
ed to an AC outlet with a protective grounding connec-
tion.


background image
O
Safety Information
Safety Information
4 TASCAM CD-01U/CD-01UPro
This product has been designed and manufactured
according to FDA regulations "title 21, CFR, chapter
1, subchapter J, based on the Radiation Control for
Health and Safety Act of 1968", and is classified as a
class 1 laser product. There is no hazardous invisible
laser radiation during operation because invisible
laser radiation emitted inside of this product is com-
pletely confined in the protective housings.
The label required in this regulation is shown 1.
Optical pickup:
Type:
KSM-900AAA
Manufacturer: SONY Corporation
Laser output: Less than 0.5 mW on the objec-
tive lens
Wavelength:
775 to 815 nm
CAUTION
· DO NOT REMOVE THE PROTECTIVE HOUSING
USING A SCREWDRIVER.
· USE OF CONTROLS OR ADJUSTMENTS OR PER-
FORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN HAZ-
ARDOUS RADIATION EXPOSURE.
· IF THIS PRODUCT DEVELOPS TROUBLE, CON-
TACT YOUR NEAREST QUALIFIED SERVICE PER-
SONNEL, AND DO NOT USE THE PRODUCT IN
ITS DAMAGED STATE.


background image
Table of contents
1 - Introduction
Supplied accessories ..................................6
Environmental considerations .....................6
Some notes and precautions ..........................6
Beware of condensation .....................6
Back up memory .................................6
Rack - mounting the unit .......................7
Handling of compact discs ...........................7
2 - Remote control unit
Some notes and precautions .......................8
Batteries ........................................................8
Inserting batteries .....................................8
3 - Connections
Audio equipment .......................................9
Connecting analog audio equipment ...........9
Connecting digital audio equipment ..........9
Power source ................................................9
4 - Features and their functions
Front panel ..................................................10
Display .......................................................11
Rear Panel ...................................................12
Remote Control Unit ..................................12
5 - Menu operation
Menu configuration ...................................14
Menu operation .........................................14
Operation basics .........................................14
6 - Playback
Discs for playback .......................................15
About finalization .......................................15
For MP3 CDs ............................................15
Playback modes ..........................................16
Basic playback operation ...........................16
Using headphones .......................................16
Track selection ............................................16
Selecting by track number .......................17
Search ..........................................................17
Frame search ...................................17
7 - Advanced operations
Auto Cue ......................................................18
Auto Ready .................................................18
Resume .........................................................18
Call ....................................................................18
Incremental play ..................................................19
Repeat playback .........................................19
A to B repeat playback ...............................19
Intro check .......................................................20
Output in monaural ..............................................20
Power on play ................................................20
Pitch control ..................................................20
Changing the playback speed without changing
the key (Key original) ...................21
Program playback .......................................21
Editing a programmed track ......................21
Adding a track to the program .................21
Deleting a programmed track ....................22
Fade in and fade out .......................................22
Relay play ................................................22
Time display switching ..............................23
End of disc/track warning ......................................23
Eject block .............................................23
Fader start/Event start ..............................23
Fader start/stop .....................................23
Event start ...........................................24
Restoring factory default settings ...................24
External parallel control ........................................24
8 - Specifications
Specifications ........................................................25
Dimensional drawing ................................26
Error Messages ...........................................26
TASCAM CD-01U/CD-01UPro
5