background image
Sony KV-DR34M97 Group M1 (GB,
CT, CS)_4-087-164-11 (1)
© 2002
Sony Corporation
KV-DR34
KV-DR29
4-087-164-11 (1)
M97
GB
Operating Instructions
· Before operating the unit, please read this manual thoroughly and retain
it for future reference.
·
·
Trinitron Color TV
CT
CS
01GB01COV-MLY.P65
10/4/01, 3:21 PM
1


background image
2
WARNING
· Dangerously high voltages are present inside the TV.
· TV operating voltage: 220 ­ 240 V AC.
· Do not plug in the power cord until you have completed making all other
connections; otherwise a minimum leakage current might flow through the antenna
and other terminals to ground.
· To avoid battery leakage and damage to the remote, remove the batteries from the
remote if you are not going to use it for several days. If any liquid leaks from the
batteries and touches your skin, immediately wash it away with water.
Do not open the cabinet and the rear cover of the
TV as high voltages and other hazards are present
inside the TV. Refer servicing and disposal of the
TV to qualified personnel.
Your TV is recommended for home use only.
Do not use the TV in any vehicle or where it may
be subject to excessive dust, heat, moisture or
vibrations.
To prevent fire or shock hazard, do not expose the
TV to rain or moisture.
Do not operate the TV if any liquid or solid object
falls into it. Have it checked immediately by
qualified personnel only.
Do not block the ventilation openings of the TV.
Do not install the TV in a confined space, such as a
bookcase or built-in cabinet.
For children's safety, do not leave children
alone with the TV. Do not allow children to
climb onto it.
Clean the TV with a dry and soft cloth.
Do not use benzine, thinner, or any other chemicals to
clean the TV. Do not attach anything (e.g., adhesive
tape, cellophane tape, glue) on the painted cabinet of
the TV. Do not scratch the picture tube.
For your own safety, do not touch any part of the
TV, the power cord and the antenna cable during
lightning storms.


background image
3
Install the TV on a stable TV stand and floor which
can support the TV set weight. Ensure that the TV
stand surface is flat and its area is larger than the
bottom area of the TV.
Do not place any objects on the TV.
Do not plug in too many appliances to the same
power socket. Do not damage the power cord.
Pull the power cord out by the plug. Do not pull
the power cord itself. Even if your TV is turned
off, it is still connected to the AC power source
(mains) as long as the power cord is plugged in.
Unplug the TV before moving it or if you are not
going to use it for several days.


background image
4
Screw the band to the TV stand and to the
provided hole at the rear of your TV.
(1) Put a cord or chain through the clamps.
(2) Screw one clamp to a wall or pillar and
the other clamp to the provided hole at
the rear of your TV.
(1) Attach each end of a cord or chain to
the provided holders at the rear of
your TV.
(2) Securely fix the attached cord or chain
to a wall or pillar using an attachment
which can support the TV set weight.
Note
· Use only the supplied screws. Use of other screws may damage the TV.
x
Securing the TV
To prevent the TV from falling, use the supplied screws, clamps and band to
secure the TV.
20 mm
3.8 mm
screws
clamps
band
or
or


background image
5
GB
Table of Contents
Installation
Getting Started ..................................... 6
Setting up your TV
("INITIAL SETUP") ............................. 7
Overview of Controls
TV front and rear panels ..................... 8
Remote control ..................................... 9
Advanced Operations
Selecting the picture and sound
modes .................................................. 11
Viewing higher quality pictures
with DRC-MF ..................................... 12
Viewing the picture in wide mode .. 12
Watching Picture-in-Picture (PIP)
(KV-DR34M97 only) .......................... 13
Selecting a TV program using PIP
(KV-DR34M97 only) .......................... 14
Listening with surround sound ....... 14
Setting the timers ............................... 15
Enjoying stereo or bilingual
programs ............................................. 16
Menu Adjustment
Introducing the menu system .......... 17
Changing the "PICTURE" setting ... 20
Changing the "SOUND" setting ..... 22
Changing the Picture-in-Picture
("PIP") setting (KV-DR34M97 only) ... 24
Changing the "SETUP" setting ........ 25
Changing the Channel Preset
("CH PRESET") setting ..................... 27
Additional Information
Connecting optional components ... 30
Troubleshooting ................................. 32
Specifications ...................... Back cover