background image
1
SERVICE MANUAL
BE-3D CHASSIS
MODEL
COMMANDER
DEST
CHASSIS NO.
MODEL
COMMANDER
DEST
CHASSIS NO.
SELF-DIAGNOSTIC FUNCTION
KV-32WS2B RM-862 French SCC-K01V-A
KV-32WS2D RM-862 AEP
SCC-K07W-A
KV-32WS2U RM-862 UK
SCC-K04R-A
®
MICR OFILM
TRINITRON®COLOR TV


background image
2
ITEM MODEL
Television System
Stereo System
Channel Coverage
Color System
French
B/G/H, D/K, L, I
GERMAN/NICAM
Stereo
VHF : E2-E12, S01-S03, R1-RX11,
F2-F10, B-Q
UHF : E21-E69, - B21-B69, R21-R69,
F21-F61
CABLE TV : S1-S20
HYPER : S21-S41
PAL, SECAM
NTSC4.43, NTSC3.58
(VIDEO IN)
AEP
B/G/H, D/K
GERMAN Stereo
VHF : E02-E12, R01-R12, A-H2
UHF : E21-E69, - R21-R69
CABLE TV : S01-S05, S1-S20
HYPER : S21-S41
PAL, SECAM
NTSC4.43, NTSC3.58
(VIDEO IN)
UK
I
NICAM Stereo
UHF : B21-B69
PAL
NTSC4.43, NTSC3.58
(VIDEO IN)
MODEL
32WS2B
32WS2D
32WS2U
Power Consumption
105 W
105 W
163 W
[PICTURE TUBE]
Super Trinitron Wide
Approx. 82cm (32 inches)
(Approx. 76 cm picture measured
diagonally)
110 degree deflection
Input/Output Terminals
[REAR]
1 21-pin Euro connector (CENELEC standard).
-
Inputs for Audio and Video signals.
-
Inputs for RGB.
-
Outputs of TV Video and Audio signals.
21-pin Euro connector.
-
inputs for Audio and Video signals.
-
inputs for S Video.
-
outputs for Audio and Video signals (selectable).
Phono Jack
-
Outputs for Audio Signals
Left/Right Speaker Terminals
Surround Speaker Terminals
[FRONT]
Video input - phono jack
Audio inputs - phono jacks
S Video input 4 pin DIN
Headphone jacks : stereo minijack
Sound output
Left/Right
2x15W (Music Power)
Centre
2x5W (Music Power)
Surround
2x10W (Music Power)
Power requirements
220 - 240V
Dimensions
Approx 906x552x566mm approx.
Weight
Approx 60kg
Supplied accessories
RM-862 Remote Commander (1)
IEC designated R6 battery (2)
Other features
Dolby Pro Logic, NICAM*, FASTEXT
*(KV-32WS2B/32WS2U only)
[RM-862]
Remote control system
infrared control
Power requirements
3V dc
2 batteries IEC designation
R6 (size AA)
Dimensions
Approx 210x56x24mm (w/h/d)
Weight
Approx 110g (Not including battery)
Design and specifications are subject to change without notice.


background image
3
WARNING (KV-32WS2U only)
The flexible mains lead is supplied connected to a B.S. 1363 fused plug
having a fuse of 5 AMP capacity. Should the fuse need to be replaced,
use a 5 AMP FUSE approved by ASTA to BS 1362, ie one that carries the
the mark.
IF THE PLUG SUPPLIED WITH THIS APPLIANCE IS NOT SUITABLE
FOR THE OUTLET SOCKETS IN YOUR HOME, IT SHOULD BE CUT
OFF AND AN APPROPRIATE PLUG FITTED. THE PLUG SEVERED
FROM THE MAINS LEAD MUST BE DESTROYED AS A PLUG WITH
BARED WIRES IS DANGEROUS IF ENGAGED IN A LIVE OUTLET
SOCKET.
When an alternative type of plug is used it should be fitted with a 5 AMP
FUSE, otherwise the circuit should be protected by a 5 AMP FUSE at the
distribution board.
Model Name
Item
KV-32WS2B
KV-32WS2D
KV-32WS2U
Pal Comb
OFF
OFF
OFF
PIP
OFF
OFF
OFF
Woofer Box
OFF
OFF
OFF
Scart 1
ON
ON
ON
Scart 2
ON
ON
ON
Front in (3)
ON
ON
ON
Scart 4
OFF
OFF
OFF
Projector
OFF
OFF
OFF
AKB in 16:9 mode
ON
ON
ON
Norm B/G/H
ON
ON
OFF
Norm I
ON
OFF
ON
Norm D/K
ON
ON
OFF
Norm AUS
OFF
OFF
OFF
Norm L
ON
OFF
OFF
Norm SAT
OFF
OFF
OFF
Norm M
OFF
OFF
OFF
Teletext
ON
ON
ON
Nicam Stereo
ON
OFF
ON
Language Preset
French
German
English
ASA
T
How to replace the fuse.
Open the fuse compartment with
a screwdriver blade and replace
the fuse.
FUSE


background image
4
21 pin connector (
1,
2 /
2 )
Connected
Not Connected (open)
* at 20Hz - 20kHz
19
17
15
13
11
9
7
5
3
1
20
18
16
14
12
10
8
6
4
2
21
Pin No
Signal
Signal level
1
Ground
2
Ground
3
Y (S signal) input
1V+/- 3dB 75 ohm, positive Sync 0.3V -3/+10dB
4
C (S signal) input
0.3V+/- 3dB 75 ohm, positive Sync
Pin No
1
2
4
Signal
Signal level
1
Audio output B
(right)
Standard level : 0.5V rms
Output impedence : Less than 1kohm*
2
Audio output B
(right)
Standard level : 0.5V rms
Output impedence : More than 10kohm*
3
Audio output A
(left)
Standard level : 0.5V rms
Output impedence : Less than 1kohm*
4
Ground (audio)
5
Ground (blue)
6
Audio input A
(left)
Standard level : 0.5V rms
Output impedence : More than 10kohm*
7
Blue input
0.7 +/- 3dB, 75 ohms positive
8
Function select
(AV control)
High state (9.5-12V) : Part mode
Low state (0-2V) : TV mode
Input impedence : More than 10K ohms
Input capacitance : Less than 2nF
9
Ground (green)
10
Open
11
Green
Green signal : 0.7 +/- 3dB, 75 ohms,
positive
12
Open
13
Ground (red)
14
Ground (blanking)
15
_
_
Red input
0.7 +/- 3dB, 75 ohms, positive
_
(S signal Chroma
input)
0.3 +/- 3dB, 75 ohms, positive
16
Blanking input
(Ys signal)
High state (1-3V) Low state (0-0.4V)
Input impedence : 75 ohms
17
Ground (video
output)
18
Ground (video
input)
19
Video output
1V +/- 3dB, 75ohms, positive sync 0.3V
(-3+10dB)
20
_
_
Video input
1V +/- 3dB, 75ohms, positive sync 0.3V
(-3+10dB)
_
Video input
Y (S signal)
1V +/- 3dB, 75ohms, positive sync 0.3V
(-3+10dB)
21
Common ground
(plug, shield)


background image
5
TABLE OF CONTENTS
CAUTION
SHORT CIRCUIT THE ANODE OF THE PICTURE TUBE AND THE
ANODE CAP TO THE METAL CHASSIS, CRT SHIELD, OR THE
CARBON PAINTED ON THE CRT, AFTER REMOVAL OF THE
ANODE CAP
WARNING !!
AN ISOLATING TRANSFORMER SHOULD BE USED DURING ANY
SERVICE WORK TO AVOID POSSIBLE SHOCK HAZARD DUE TO
LIVE CHASSIS. THE CHASSIS OF THIS RECEIVER IS DIRECTLY
CONNECTED TO THE POWER LINE.
SAFETY-RELATED COMPONENT WARNING !!
COMPONENTS IDENTIFIED BY SHADING AND MARKED
ON
THE SCHEMATIC DIAGRAMS, EXPLODED VIEWS AND IN THE
PARTS LIST ARE CRITICAL FOR SAFE OPERATION. REPLACE
THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
ATTENTION
APRES AVOIR DECONNECTE LE CAP DE'LANODE,
COURT-CIRCUITER L'ANODE DU TUBE CATHODIQUE ET
CELUI DE L'ANODE DU CAP AU CHASSIS METALLIQUE
DE L'APPAREIL, OU AU COUCHE DE CARBONE PEINTE
SUR LE TUBE CATHODIQUE OU AU BLINDAGE DU TUBE
CATHODIQUE.
ATTENTION !!
AFIN D'EVITER TOUT RISQUE D'ELECTROCUTION PROVENANT
D'UN CHÁSSIS SOUS TENTION, UN TRANSFORMATEUR
D'ISOLEMENT DOIT ETRE UTILISÈ LORS DE TOUT DÈPANNAGE.
LE CHÁSSIS DE CE RÈCEPTEUR EST DIRECTMENT RACCORDÈ
Á L'ALIMENTATION SECTEUR.
ATTENTION AUX COMPOSANTS RELATIFS Á LA
SÈCURITÈ !!
LES COMPOSANTS IDENTIFIÈS PAR UNE TRAME ET PAR UNE
MARQUE
SUR LES SCHÈMAS DE PRINCIPE, LES VUES
EXPLOSÈES ET LES LISTES DE PIECES SONT D'UNE IMPORTANCE
CRITIQUE POUR LA SÈCURITÈ DU FONCTIONNEMENT, NE LES
REMPLACER QUE PAR DES COMPSANTS SONY DONT LE NUMÈRO
DE PIÈCE EST INDIQUÈ DANS LE PRÈSENT MANUEL OU DANS
DES SUPPLÈMENTS PUBLIÈS PAR SONY.
Section
Title
Page
Section
Title
Page
1. GENERAL
Overview
.....................6
Getting Started
.....................8
TV Operation
.....................9
Advanced Operations
.....................10
Teletext
.....................16
Optional Equipment
.....................17
Troubleshooting
.....................19
2. DISASSEMBLY
2-1.
Rear Cover Removal
.....................20
2-2.
Speaker Removal
.....................20
2-3.
Chassis Assy Removal
.....................20
2-4-1. Service Position (1)
.....................20
2-4-2. Service Position (2)
.....................21
2-5.
A Board Removal
.....................21
2-6.
A Extension Board
.....................21
2-7.
A1 Extension boards
.....................21
2-8.
Picture Tube Removal
.....................22
Removal of Anode Cap
.....................22
Removal and Replacement of the
Main - Bracket Bottom Plates
.....................23
3. SET-UP ADJUSTMENTS
3-1.
Beam Landing
.....................24
3-2.
Convergence
.....................25
3-3.
White Balance
.....................27
4. CIRCUIT ADJUSTMENTS
4-1.
Electrical Adjustments
.....................28
4-2.
Test Mode 2
.....................31
4-3.
BE-3D Self Diagnostic Software
.....................33
5. DIAGRAMS
5-1.
Block Diagrams
.....................35
5-2.
Circuit Board Location
.....................43
5-3.
Schematic Diagrams and
Printed Wiring Boards
.....................43
*
K1 Board
.....................44
*
D Board
.....................51
*
A Board
.....................56
*
C Board
.....................66
*
VM Board
.....................67
*
A1 Board
.....................71
*
J Board
.....................72
*
D4 Board
.....................74
*
IF Board
[VIF (AEP), VIF UK]
.....................77
*
IF Board [VIF (FR)]
.....................77
IC Blocks
.....................79
5-4.
Semiconductors
.....................81
6. EXPLODED VIEWS
6-1.
Chassis
.....................83
6-2.
Picture Tube
.....................84
7. ELECTRICAL PARTS LIST
.....................85