background image
1
Ver 1.1 2003. 02
Model Name Using Similar Mechanism
CDX-CA700/CA700X
CD Drive Mechanism Type
MG-393XA-121//Q
Optical Pick-up Name
KSS-720A
SERVICE MANUAL
US Model
CDX-CA705M
FM/AM COMPACT DISC PLAYER
AUDIO POWER SPECIFICATIONS (US Model)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23.2 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more
than 5% total harmonic distortion.
CD player section
Signal-to-noise ratio
90 dB
Frequency response
10 ­ 20,000 Hz
Wow and flutter
Below measurable limit
Tuner section
FM
Tuning range
FM tuning interval;
50 kHz/200 kHz
switchable
87.5 ­ 108 MHz (at 50 kHz step)
87.5 ­ 107.9 MHz (at 200 kHz step)
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Usable sensitivity
8 dBf
Selectivity
75 dB at 400 kHz
Signal-to-noise ratio
66 dB (stereo),
72 dB (mono)
Harmonic distortion at 1 kHz
0.6% (stereo),
0.3% (mono)
Separation
35 dB at 1 kHz
Frequency response
30 ­ 15,000 Hz
AM
Tuning range
AM tuning interval;
9 kHz/10 kHz
switchable
531 ­ 1,602 kHz (at 9 kHz step)
530 ­ 1,710 kHz (at 10 kHz step)
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity
30 µV
SPECIFICATIONS
Power amplifier section
Outputs
Speaker outputs
(sure seal connectors)
Speaker impedance
4 ­ 8 ohms
Maximum power output 52 W
× 4 (at 4 ohms)
General
Outputs
Audio outputs (front/rear)
Power antenna relay control terminal
Power amplifier control terminal
Inputs
Telephone ATT control terminal
Illumination control terminal
BUS control input terminal
BUS audio input terminal
Remote controller input terminal
Antenna input terminal
Tone controls
Bass ±10 dB at 62 Hz
Treble ±10 dB at 16 kHz
Loudness
±8 dB at 100 Hz
±2 dB at 10 kHz
· The tuner and CD sections have no adjustments.
Sony Corporation
e Vehicle Company
Published by Sony Engineering Corporation
9-874-008-02
2003B0400-1
© 2003. 02
­ Continued on next page ­


background image
2
CDX-CA705M
optical pick-up block
semi-fixed resistor
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
· Never reuse a disconnected chip component.
· Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
This label is located on the bottom of the chassis.
This label is located on the drive unit's internal chassis.
If the optical pick-up block is defective, please replace the whole
optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical
pick-up block.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
TEST DISCS
This set can playback CD-R and CD-ROM discs. The following
test discs should be used to check the capability:
CD-R test disc TCD-R082LMT (Part No. J-2502-063-1)
CD-RW test disc TCD-W082L (Part No. J-2502-063-2)
Notes on CD-R/CD-RW discs
· You can play CD-Rs (recordable CDs)/CD-RWs (rewritable CDs)
designed for audio use on this unit.
Look for these marks to distinguish CD-Rs/CD-RWs for audio
use.
These marks denote that a disc is not for audio use.
· Some CD-Rs/CD-RWs (depending on the equipment used for
its recording or the condition of the disc) may not play on this
unit.
· You cannot play a CD-R/a CD-RW that is not finalized.
A process necessary for a recorded CD-R/CD-RW disc to be
played on the audio CD player.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
Power requirements
12 V DC car battery
(negative ground)
Dimensions
Approx. 178
× 50 × 178 mm
(7 1/8
× 2 × 7 1/8 in.) (w/h/d)
Mounting dimensions
Approx. 182
× 53 × 162 mm
(7 1/4
× 2 1/8 × 6 1/2 in.) (w/h/d)
Mass
Approx. 1.2 kg
(2 lb. 10 oz.)
Supplied accessories
Parts for installation and connections (1 set)
Front panel case (1)
Card remote commander (1)
Note
This unit cannot be connected to a digital preamplifier or an equalizer.
Design and specifications are subject to change without
notice.


background image
3
TABLE OF CONTENTS
1. GENERAL
Location of controls ................................................................. 4
Connections ............................................................................. 5
2. DISASSEMBLY
2-1. Sub Panel Assy .................................................................... 7
2-2. CD Mechanism Block ......................................................... 8
2-3. Main Board ......................................................................... 8
2-4. Heat Sink ............................................................................. 9
2-5. Chassis (T.U) Assy .............................................................. 9
2-6. Disc In Board .................................................................... 10
2-7. Servo Board ....................................................................... 10
2-8. Shaft Roller Assy, Load Board .......................................... 11
2-9. Floating Block Assy .......................................................... 11
2-10. Optical Pick-up Block ....................................................... 12
3. DIAGRAMS
3-1. IC Pin Description ............................................................. 13
3-2. Block Diagram ­CD Section­ ........................................... 15
3-3. Block Diagram ­Tuner Section­ ....................................... 16
3-4. Block Diagram ­Display Section­ .................................... 17
3-5. Circuit Boards Location .................................................... 17
3-6. Printed Wiring Boards ­CD Mechanism Section­ ............ 18
3-7. Schematic Diagram ­CD Mechanism Section­ ................ 20
3-8. Schematic Diagram ­Main Section (1/3)­ ........................ 21
3-9. Schematic Diagram ­Main Section (2/3)­ ........................ 22
3-10. Schematic Diagram ­Main Section (3/3)­ ........................ 23
3-11. Printed Wiring Board ­Main Section­ .............................. 24
3-12. Printed Wiring Board ­Relay Section­ ............................. 26
3-13. Schematic Diagram ­Relay Section­ ................................ 27
3-14. Printed Wiring Board ­Key Section­ ................................ 28
3-15. Schematic Diagram ­Key Section­ ................................... 29
4. EXPLODED VIEWS
4-1. Chassis Section ................................................................. 33
4-2. Main Board Section .......................................................... 34
4-3. Front panel Section ........................................................... 35
4-4. CD Mechanism Section (1) ............................................... 36
4-5. CD Mechanism Section (2) ............................................... 37
4-6. CD Mechanism Section (3) ............................................... 38
5. ELECTRICAL PARTS LIST ........................................ 39
CDX-CA705M
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension cable)
as shown below.
· Connect the MAIN board (CNP301) and the SERVO board (CN1)
with the extension cable (Part No. J-2502-062-1).
MAIN BOARD CNP301
SERVO BOARD CN1


background image
4
CDX-CA705M
SECTION 1
GENERAL
This section is extracted
from instruction manual.


background image
5
CDX-CA705M
Connections