background image
ORDER NO.
PIONEER ELECTRONIC CORPORATION 4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS SERVICE, INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER ELECTRONIC (EUROPE) N.V. Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER ELECTRONIC CORPORATION 1998
HTV-C1
DDXJ
AC110­127V/220­230V/240V
With the voltage selector
ADXJ
AC power supplied from power trans-
former's secondary of other system component
This product is a system component. This product does not function properly when independent;
to avoid malfunctions, be sure to connect it to the prescribed system component, otherwise
damage may result. The Powered Subwoofer HTV-SW1 is a part of the Hometheater System HTV-
1.
POWERED SUBWOOFER
RRV2060
T­ZZR NOV. 1998 Printed in Japan
HTV-SW1
1. SAFETY INFORMATION .................................... 2
2. EXPLODED VIEWS AND PARTS LIST ............. 3
3. SCHEMATIC DIAGRAM ................................... 10
4. PCB CONNECTION DIAGRAM ....................... 24
5. PCB PARTS LIST ............................................. 36
6. ADJUSTMENT .................................................. 39
7.GENERAL INFORMATION ............................... 40
7.1 PARTS ........................................................ 40
CONTENTS
7.1.1 IC ........................................................... 40
7.1.2 DISPLAY ................................................ 42
7.2 DIAGNOSIS ................................................ 43
7.3 TEST MODE(HTV-C1) ............................... 45
7.4 INDEPENDENT OPERATION DIAGNOSIS46
7.5 BACKUP FUNCTION (HTV-C1) ................. 47
7.6 BLOCK DIAGRAM ...................................... 48
8.PANEL FACILITIES AND SPECIFICATIONS ..... 50
THIS MANUAL IS APPLICABLE TO THE FOLLOWING MODEL(S) AND TYPE(S).
CONTROL CENTER
· HTV-SW1
· HTV-C1
SURROUND MODE
STANDBY/ON
DISPLAY
INPUT
VOLUME
Hometheater System
Control Center
HTV-1
HTV-C1 (this service manual)
(service manual RRV2063)
Powered Subwoofer
HTV-SW1 (this service manual)
The voltage can be converted by
the following method.
Model
HTV-SW1
HTV-C1
Type
Power Requirement
Power Amp
HTV-A1 (this service manual)


background image
HTV-SW1, HTV-C1
2
1. SAFETY INFORMATION
1. SAFETY PRECAUTIONS
The following check should be performed for the
continued protection of the customer and service
technician.
ANY MEASUREMENTS NOT WITHIN THE LIMITS
OUTLINED ABOVE ARE INDICATIVE OF A PO-
TENTIAL SHOCK HAZARD AND MUST BE COR-
RECTED BEFORE RETURNING THE APPLIANCE
TO THE CUSTOMER.
2. PRODUCT SAFETY NOTICE
Many electrical and mechanical parts in the appli-
ance have special safety related characteristics. These
are often not evident from visual inspection nor the
protection afforded by them necessarily can be ob-
tained by using replacement components rated for
voltage, wattage , etc.
Replacement parts which have
these special safety
characteristics are identified in
this Service Manual.
Electrical components having such features are
identified by marking with a
on the schematics and
on the parts list in this Service Manual.
The use of a substitute replacement component which
does not have the same safety characteristics as the
PIONEER recommended replacement one, shown in
the parts list in this Service Manual, may create shock,
fire, or other hazards.
Product Safety is continuously under review and
new instructions are issued from time to time. For
the latest information, always consult the current
PIONEER Service Manual. A subscription to, or
ad-
ditional copies of, PIONEER Service Manual may be
obtained at a nominal charge from PIONEER.
LEAKAGE CURRENT CHECK
Measure leakage current to a known earth ground
(water pipe, conduit, etc.) by connecting a leakage
current tester such as Simpson Model 229-2 or
equivalent between the earth ground and all exposed
metal parts of the appliance (input/output terminals,
screwheads, metal overlays, control shaft, etc.). Plug
the AC line cord of the appliance directly into a 120V
AC 60 Hz outlet and turn the AC power switch on. Any
current measured must not exceed 0.5 mA.
(FOR USA MODEL ONLY)
Also test with plug
reversed
(Using AC adapter
plug as required)
Device
under
test
Test all exposed
metal surfaces
Earth ground
Leakage
current
tester
Reading should
not be above
0.5 mA
AC Leakage Test
This service manual is intended for qualified service technicians; it is not meant for the casual
do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trained to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to
cause cancer, birth defects or other reproductive harm.
Health & Safety Cod e Section 25249.6 ­ Proposition 65
REMARQUE
(POUR MODÈLE CANADIEN SEULEMENT)
Les symboles de fusible
(fusible de type rapide) et/ou
(fusible de type lent) sur CCI indiquent que les
pièces de remplacement doivent avoir la même désignation.
NOTICE
(FOR CANADIAN MODEL ONLY)
Fuse symbols
(fast operating fuse) and/or
(slow operating fuse) on PCB indicate that replacement parts
must be of identical designation.


background image
HTV-SW1, HTV-C1
3
2. EXPLODED VIEWS AND PARTS LIST
NOTES :
÷ Parts marked by " NSP " are generally unavailable because they are not in our Master Spare Parts List.
÷ The
mark found on some component parts indicates the importance of the safety factor of the part.
Therefore, when replacing, be sure to use parts of identical designation.
÷ Screw adjacent to
mark on the product are used for disassembly.
Mark No.
Description
Part No.
Rear
4
3
1(1/4)
1(3/4)
1(4/4)
1(2/4)
6
2(1/4)
2(3/4)
2(4/4)
2(2/4)
5
2.2 HTV-SW1
2.1.1 PACKING
÷ PACKING PARTS LIST(HTV-SW1)
1
Protector Top
SHA2140
2
Protector Bottom
SHA2141
3
Protection Sheet S6
SHC1726
4
Protection Sheet S7
SHC1727
5
Packing Case
SHG2124
NSP
6
Polyethylene Bag
SHL1227
(0.03
× 115 × 270)


background image
HTV-SW1, HTV-C1
4
Mark No.
Description
Part No.
÷ EXTERIOR(Cabinet HTV-SW1) PARTS
LIST
NSP
1
Cabinet
SMM1821
NSP
2
Power AMP
HTV-A1/DDXJ
3
Connecting Cord
SDF1072
NSP
4
Paper Port tube
SMR1283
5
Foot
SNK2274
NSP
6
CAUTION LABEL
SRR1012
7
Speaker
Q20EU82-52F
8
Screw
BYC40P200FZB
9
Bind Tapping Screw
BYC40P300FZK
NSP
10
Logo 40
SAM1452
2.1.2 EXTERIOR ( Cabinet HTV-SW1 )
5
3
9
9
10
4
1
A
2
8
8
8
Refer to "2.1.3 POWER AMP SECTION"
A
A
6
7
8
8
5


background image
HTV-SW1, HTV-C1
5
2.1.3 EXTERIOR ( POWER AMP HTV-A1)
1
24
29
29
23
23
28
27
23
7
8
23
22
22
4
6
3
25
14
20
23
29
11
23
29
23
5
23
23
23
23
23
23
23
19
23 12
26
23
10
9
15
13
29
15
18
16
21
16
2
18
18
17
22
22
33
30
A
B
E
A
B
D
C
D
C
F
F
E
G
G
23
32
23
29
31
23