High power CD player with FM/MW/LW tuner
Syntoniseur FM/MW/LW (PO/GO) avec lecteur de CD
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know how to operate
your model properly. After you have finished reading the instructions, keep this man-
ual in a safe place for future reference.
Before You Start
About this unit 3
Protecting your unit from theft 3
Removing the front panel 3
Attaching the front panel 3
Head unit 4
Turning the unit on and selecting a
Turning the unit off 5
Listening to the radio 6
Storing and recalling broadcast
Tuning in strong signals 6
Storing the strongest broadcast
Built-in CD Player
Playing a CD 8
Repeating play 8
Pausing CD playback 8
Introduction of audio adjustments 9
Using balance adjustment 9
Using the BTB (bass treble booster) 9
Adjusting BTB 9
Adjusting loudness 10
Adjusting source levels 10
Adjusting initial settings 11
Setting the FM tuning step 11
Saving the battery consumption 11
Understanding built-in CD player error
CD player and care 12
CD-R/CD-RW discs 12
About this unit
The tuner frequencies on this unit are allo-
cated for use in Western Europe, Asia, the
Middle East, Africa and Oceania.
! Do not allow this unit to come into contact
with liquids. Electrical shock could result.
Also, this unit damage, smoke, and overheat
could result from contact with liquids.
! A CLASS 1 LASER PRODUCT label is affixed
to the bottom of this unit.
! The Pioneer CarStereo-Pass is for use only in
! Keep this manual handy as a reference for op-
erating procedures and precautions.
! Always keep the volume low enough so that
you can hear sounds from outside the vehicle.
! Protect this unit from moisture.
! If the battery is disconnected or discharged,
the preset memory will be erased and must be
! Should this product fail to operate properly,
contact your dealer or nearest authorized Pio-
neer Service Station.
Protecting your unit from
The front panel can be detached from the
head unit and stored in the protective case
provided to discourage theft.
! Never use force or grip the display and the
buttons too tightly when removing or attach-
! Avoid subjecting the front panel to excessive
! Keep the front panel out of direct sunlight and
Removing the front panel
1 Press DETACH to release the front
Press DETACH and the right side of the panel
is released from the head unit.
2 Grab the front panel and remove.
Grab the right side of the front panel and pull
away to the left. The front panel will be de-
tached from the head unit.
3Put the front panel into the protective
case provided for safe keeping.
Attaching the front panel
1 Place the front panel flat against the
2 Press the front panel into the face of
the head unit until it is firmly seated.
Before You Start
1 BSM button
Press and hold to turn BSM function on or
2 BTB button
Press to select various BTB (bass treble
3 Disc loading slot
Insert a disc to play.
4 LOUDNESS button
Press to turn loudness on or off.
5 EJECT button
Press to eject a CD from your built-in CD
6 AUDIO button
Press to select various sound quality con-
7 c/d buttons
Press to do manual seek tuning, fast for-
ward, reverse and track search controls.
Also used for controlling functions.
8 DETACH button
Press to remove the front panel from the
9 BAND button
Press to select among two FM and MW/LW
bands and cancel the control mode of func-
a LOCAL button
Press to turn local function on or off.
b 16 buttons
Press for preset tuning.
c SOURCE button
This unit is turned on by selecting a source.
Press to cycle through all the available
d VOLUME (+/) buttons
Press to increase or decrease the volume.
Turning the unit on and
selecting a source
You can select a source you want to listen to.
To switch to the built-in CD player, load a disc
in the unit (refer to page 8).
% Press SOURCE to select a source.
Press SOURCE repeatedly to switch between
the following sources:
Built-in CD playerTuner
When you select a source the unit is turned
! When no disc has been set in the unit, the
source will not switch to the built-in CD player.
! When this units blue/white lead is connected
to the vehicles auto-antenna relay control
terminal, the vehicles antenna extends when
this units source is turned on. To retract the
antenna, turn the source off.
Turning the unit off
% Press SOURCE and hold until the unit