background image
STEREO INTEGRATED AMPLIFIER
B60-3742-08 00 KO (T, M)
OC
99/12 11 10 9 8 7 6 5 4 3 2 1 98/12 11 10 9 8 7 6 5 4 3
KENWOOD CORPORATION
INSTRUCTION MANUAL
KAF-3010R
KAF-1010


background image
2
KAF-3010R/1010 (En)
Before applying power
Units are designed for operation as follows.
Europe and U.K. ..................................................................... AC 230 V only
*Other countries ............................. AC 110-120 /220-240 V switchable
For the United Kingdom
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use only a
13-Amp ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing the fuse in
the moulded plug.
3. Do not cut off the mains plug from this equipment. If the plug
fitted is not suitable for the power points in your home or the
cable is too short to reach a power point, then obtain an
appropriate safety approved extension lead or adapter, or
consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and
dispose of the plug immediately, to avoid a possible shock
hazard by inadvertent connection to the mains supply.
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code.
Blue
: Neutral
Brown : Live
Do not connect those leads to the earth terminal of a
three-pin plug.
Safety precautions
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE"
WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE
A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER
TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS
IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
Unpacking
Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit
was shipped to you directly, notify the shipping company without delay. Only the consignee (the person or company receiving the unit) can file
a claim against the carrier for shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the future.
Caution : Read this page carefully to ensure safe operation.
*For other countries
This unit operates on 110-120 or 220-240 volts AC . The AC voltage
selector switch on the rear panel is set to the voltage that prevails in
the area to which the unit is shipped. Before connecting the power
cord to your AC outlet, make sure that the setting position of this
switch matches your line voltage. If not, it must be set to your voltage
in accordance with the following direction.
AC voltage selection
AC voltage selector switch
Move switch lever to match
your line voltage with a small
screwdriver or other pointed
tool.
Note:
Our warranty does not cover damage caused by excessive line voltage
due to improper setting of the AC voltage selector switch.
AC 220--
240V
AC 110--
120V


background image
3
KAF-3010R/1010 (En)
Special features
SOURCE DIRECT
Lets you enjoy high quality sound from the music source selected by the INPUT SELECTOR.
Caution : Read the pages marked
carefully to ensure safe operation.
Contents
Before applying power
.................................................................................................................................................. 2
Before applying power .................................................................................................................... 2
Safety precautions .......................................................................................................................... 2
Special features
.................................................................................................................................................. 3
System connection
.................................................................................................................................................. 4
The system control connections .......................................................................................................... 5
Connection of speakers ........................................................................................................................ 6
Controls and indicators
.................................................................................................................................................. 7
Main unit ................................................................................................................................................ 7
Remote control unit ............................................................................................................................... 8
Operation of remote control unit
.................................................................................................................................................. 9
Playing music
................................................................................................................................................ 10
Normal Playback .................................................................................................................................. 10
Sound adjustment functions
................................................................................................................................................ 11
To mute sound temporarily ................................................................................................................ 11
Adjusting the left/right sound balance ............................................................................................... 11
Adjusting the tone ............................................................................................................................... 11
Emphasizing deep bass (LOUDNESS) ............................................................................................... 11
To listen through headphones ............................................................................................................ 12
Listening to high quality sound from a music source (SOURCE DIRECT) .................................... 12
Recording
................................................................................................................................................ 13
To record a music source ................................................................................................................... 13
In case of difficulty
................................................................................................................................................ 14
Specifications
................................................................................................................................................ 15
Accessories
Remote control unit (1)
(KAF-3010R only)
Batteries (R6/SUM-3) (2)
(KAF-3010R only)
AC plug adaptor (1)
Use to adapt the plug on
the power cord to the
shape of the wall outlet.
(Accessory only for
regions where use is
necessary.)


background image
4
KAF-3010R/1010 (En)
SL 16 XS-8
­+
PHONO
CD
TUNER
TAPE
SYSTEM CONTROL
SPEAKERS
AC OUTLETS
UNSWITCHED
100W MAX.
SWITCHED TOTAL
200W MAX.
i
A or B : 4­16
, A and B : 8­16 j
REC
PLAY
REC
PLAY
MD
SIGNAL GND
L
R
L
R
L
R
B
A
AC 220--
240V
AC 110--
120V
System connection
Make connections as shown below.
When connecting the related system components, refer also
to the instruction manuals of the related components.
Do not plug in the power lead until all connections are
completed.
To wall
AC outlet
MD recorder
Turntable
CD player
Tuner
Tape deck
* Caution (for U.K.)
When using the AC outlets equipped with unit, be sure to
consult your dealer for the corresponding plug.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around
the unit (from the largest outer dimensions including projec-
tions) equal to, or greater than, shown below.
Left and right panels: 10 cm, Rear panel: 10 cm, Top panel: 50 cm
System control cord
System control cord
System control cord
PLAY OUT
REC IN
PLAY OUT
REC IN
* U.K.
Other countries
About the AC outlet for other components
(KAF-3010R only)
SWITCHED outlet (maximum capacity 200 W)
You can connect a power cord from a cassette deck, record player,
or CD player (etc.). If you leave the POWER switch of that
component in the ON position, it will turn ON/OFF together with
the REMOTE POWER key on this unit, for your convenience. Do
not connect a component that consume more than 200 W total.
AC outlets (KAF-3010R only)
Audio cords
Shape of AC outlets
AC voltage selector
switch (only some
areas)
Malfunction of microcomputer
If operation is not possible or erroneous display appears
even though all connections have been made properly,
reset the microcomputer referring to "In case of diffi-
culty".
$
SYSTEM CONTROL selector
switch and terminals
(KAF-3010R only)


background image
5
KAF-3010R/1010 (En)
Connecting system control cords after connecting a KENWOOD audio component system lets you take advantage of convenient
system control operations.
There are two KENWOOD system control modes. Make connections according to the groups of terminal symbols shown below.
[XS8 ] Mode : lets you combine
F , f, and terminals
[SL16] Mode : for
terminals only
This unit corresponds to [XS8] and to [SL16].
÷ When all units in system control connection are set to [XS8] mode, set the SYSREM CONTROL selector switch on the rear to the
[XS8] side and connect.
÷ When all units in system control connection are set to [SL16] mode, set the SYSREM CONTROL selector switch on the rear to the
[SL16] side and connect.
The system control operations
Remote Control
The remote control supplied with this unit can also be used to control the other components in the system.
Automatic Operation (except [XR] equipment)
Automatically switches the input selector on the amp or receiver when you start playback from this unit.
Synchronized Recording (except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from CD, MD, or LD.
Notes
Notes
The system control connections (only for KAF-3010R)
1. [SL16] equipment cannot be combined with [XR], [XS], and [XS8] equipment for
system operations. If your equipment consists of this kind of combination, please
do not connect any system control cords, Even without system control cords,
normal operations can be carried out without affecting performance.
2. If your amp or receiver does not have a system control terminal, do not connect
any system control cords to the system control terminals on the other compo-
nents.
3. Do not connect system control cords to any components other than those speci-
fied by KENWOOD. It may cause a malfunction and damage your equipment.
4. Be sure the system control plugs are inserted all the way in to the system control
terminals.
SL 16 XS-8
­+
PHONO
CD
TUNER
TAPE
SYSTEM CONTROL
SPEAKERS
AC OUTLETS
UNSWITCHED
100W MAX.
SWITCHED TOTAL
200W MAX.
i
A or B : 4­16
, A and B : 8­16 j
REC
PLAY
REC
PLAY
MD
SIGNAL GND
L
R
L
R
L
R
B
A
SL 16 XS-8
SYSTEM CONTROL
SYSTEM CONTROL
selector switch
No matter to which of the two terminals
the connection is made, the use method is
the same.