background image
UX-G5
--Consists of CA-UXG5 and SP-UXG5
LVT1349-003A
[UJ]
English
MICRO COMPONENT SYSTEM
INSTRUCTIONS
Cover[UJ].fm Page 1 Thursday, June 9, 2005 11:15 AM


background image
G-1
Warnings, Cautions and Others
CAUTION--
(standby/on) button!
Disconnect the mains plug to shut the power off completely
(all lamps and indications go off). The
button in any
position does not disconnect the mains line.
· When the unit is on standby, the STANDBY lamp lights in red.
· When the unit is turned on, the STANDBY lamp goes off.
The power can be remote controlled.
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1. Do not remove screws, covers or cabinet.
2. Do not expose this appliance to rain or moisture.
CAUTION
· Do not block the ventilation openings or holes.
(If the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able to get
out.)
· Do not place any naked flame sources, such as lighted
candles, on the apparatus.
· When discarding batteries, environmental problems must
be considered and local rules or laws governing the
disposal of these batteries must be followed strictly.
· Do not expose this apparatus to rain, moisture, dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
IMPORTANT FOR LASER PRODUCTS
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are no user
serviceable parts inside the Unit; leave all servicing to
qualified service personnel.
3. CAUTION: Visible and invisible laser radiation when
open and interlock failed or defeated. Avoid direct
exposure to beam.
4. REPRODUCTION OF LABEL: CAUTION LABEL,
PLACED INSIDE UNIT.
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:
1. Front:
No obstructions and open spacing.
2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
3. Bottom:
Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height
of 10 cm or more.
About the cooling fan
A cooling fan is mounted on the rear panel of the unit to prevent abnormal temperature inside the unit, thus assuring normal
operation of the unit. The cooling fan automatically starts rotating to intake external cool air when the volume is increased
up to more than a certain level.
10 cm
15 cm
1 cm
15 cm
15 cm
1 cm
15 cm
15 cm
Front
Side
SP-UXG5
CA-UXG5
SP-UXG5
CA-UXG5
Safty[UJ].fm Page 1 Monday, June 6, 2005 3:32 PM


background image
1
Contents
Introduction .....................................................2
Precautions...................................................................... 2
How to Read This Manual.............................................. 2
Getting Started ................................................3
Step 1: Unpack................................................................ 3
Step 2: Prepare the Remote Control ............................... 3
Step 3: Hook Up ............................................................. 4
Before Operating the System .........................7
Daily Operations--Playback ..........................8
Listening to the Radio..................................................... 9
Playing Back a Disc...................................................... 10
Playing Back a Tape ..................................................... 12
Playing Back Other Equipment .................................... 12
Daily Operations
--Sound & Other Adjustments ................13
Adjusting the Volume................................................... 13
Adjusting the Sound ..................................................... 13
Changing the Display Brightness--DIMMER............. 14
Setting the Clock .......................................................... 14
Turning Off the Power Automatically.......................... 14
Advanced Disc Operations ...........................15
Programming the Playing Order--Program Play ......... 15
Playing at Random--Random Play .............................. 16
Playing Repeatedly--Repeat Play................................ 17
Prohibiting Disc Ejection--Child Lock ....................... 17
Advanced Tape Operations ..........................18
Recording on a Tape..................................................... 18
Synchronized Disc Recording ...................................... 19
Timer Operations ..........................................20
Setting the Timer .......................................................... 20
Additional Information ................................22
Learning More about This System ............................... 22
Troubleshooting............................................................ 24
Maintenance.................................................................. 25
Specifications................................................................ 25
Parts Index .................................................................... 26
UX-G5[UJ].book Page 1 Friday, June 10, 2005 1:07 PM


background image
2
Introduction
Precautions
Installation
· Install in a place which is level, dry and neither too hot nor
too cold--between 5°C and 35°C.
· Install the System in a location with adequate ventilation to
prevent internal heat buildup inside the System.
· Leave sufficient distance between the System and the TV.
· Keep the speakers away from the TV to avoid interference
with TV.
Power sources
· When unplugging the System from the wall outlet, always
pull on the plug, not the AC power cord.
Moisture condensation
Moisture may condense on the lenses inside the System in
the following cases:
· After starting to heat the room
· In a damp room
· If the System is brought directly from a cold to a warm
place
Should this occur, the System may malfunction. In this case,
leave the System turned on for a few hours until the moisture
evaporates, unplug the AC power cord, then plug it in again.
Internal heat
·A cooling fan is mounted on the rear panel to prevent heat
buildup inside the main unit (see page G-1).
Others
· Should any metallic object or liquid fall into the System,
unplug the AC power cord and consult your dealer before
operating any further.
· If you are not going to operate the System for an extended
period of time, unplug the AC power cord from the wall outlet.
If anything goes wrong, unplug the AC power cord and
consult your dealer.
How to Read This Manual
To make this manual as simple and easy-to-understand as
possible, we have adapted the following methods:
· Button and control operations are explained as listed in the
table below. In this manual, the operations using the remote
control is mainly explained; however, you can use the
buttons and controls on the main unit if they have the same
(or similar) name and marks.
· Some related tips and notes are explained later in the
sections "Learning More about This System" and
"Troubleshooting," but not in the same section
explaining the operations. If you want to know more about
the functions, or if you have a doubt about the functions, go
to these sections and you will find the answers.
DO NOT install the System in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust or vibration.
DO NOT handle the AC power cord with wet
hands.
For safety, observe the following carefully:
· Make sure there is good ventilation around
the main unit. Poor ventilation could
overheat and damage the System.
· DO NOT block the cooling fan and the
ventilation openings or holes. If they are
blocked by a newspaper or cloth, etc., the
heat may not be able to get out.
DO NOT disassemble the System since there
are no user serviceable parts inside.
Indicates that you press the button
briefly.
Indicates that you press the button
briefly and repeatedly
until an option
you want is selected.
Indicates that you press one of the
buttons.
Indicates that you press and hold the
button for specified seconds.
· The number inside the arrow
indicates the period of press (in this
example, 2 seconds).
· If no number is inside the arrow,
press and hold until the entire
procedure is complete or until you
get a result you want.
Indicates that you turn the control
toward the specified direction(s).
Indicates that this operation is only possible
using the remote control.
Indicates that this operation is only possible
using the buttons and controls on the main
unit.
2 sec.
Remote
ONLY
Main Unit
ONLY
UX-G5[UJ].book Page 2 Friday, June 10, 2005 1:07 PM


background image
3
Getting Started
Step
1: Unpack
After unpacking, check to be sure that you have all the
following items. The number in parentheses indicates the
quantity of each piece supplied.
· FM antenna (1)
· AM loop antenna (1)
· Remote control (1)
· Batteries (2)
· AC plug adapter (1)
If any item is missing, consult your dealer immediately.
Step
2: Prepare the Remote Control
Insert the batteries into the remote control by matching the
polarity (+ and ­) correctly.
AM
EXT
GND
AM
LOOP
ANTENNA
Step
1:Unpack the package and
check the accessories.
Step 2: Prepare the remote control.
Step 3: Hook up the components such
as AM/FM antennas, speakers,
etc. (see pages 4 to 6).
Finally plug the AC power cord.
Now you can operate the System.
· DO NOT use an old battery together with a
new one.
· DO NOT use different types of batteries
together.
· DO NOT expose batteries to heat or flame.
· DO NOT leave the batteries in the battery
compartment when you are not going to use
the remote control for an extended period of
time. Otherwise, the remote control will be
damaged from battery leakage.
3
2
1
R6(SUM-3)/AA(15F)
UX-G5[UJ].book Page 3 Friday, June 10, 2005 1:07 PM