INSTRUCTIONS
UX-A52R
-- Consists of CA-UXA52R and SP-UXA52
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
GVT0071-008A
[B]
MICRO COMPONENT SYSTEM
STANDBY/ON
COMPACT
DIGITAL AUDIO
MICRO COMPONENT SYSTEM UX-A52R
PHONES
COLOR
CLOCK
/TIMER
FM MODE
DISPLAY
SOUND
MODE
AHB
PRO
SET
CANCEL
CD
DIMMER
1
2
3
FM/AM
REPEAT
TAPE
STANDBY/ON
SLEEP
PLAY MODE
BEEP
VOLUME
4
5
6
7
8
9
10
0
+
10
RM-SUXA52R
REV.MODE
AUX/MD
SELECT
+
- RDS -
CONTROL
PTY
DISPLAY
TA/NEWS
/INFO
UX-A52R[B]_COVER_f
01.12.4, 7:56 PM
1
Warnings, Cautions and Others
IMPORTANT for the U.K.
DO NOT cut off the mains plug from this equipment. If the
plug fitted is not suitable for the power points in your
home or the cable is too short to reach a power point,
then obtain an appropriate safety approved extension
lead or consult your dealer.
BE SURE to replace the fuse only with an identical
approved type, as originally fitted.
If nonetheless the mains plug is cut off ensure to remove
the fuse and dispose of the plug immediately, to avoid a
possible shock hazard by inadvertent connection to the
mains supply.
If this product is not supplied fitted with a mains plug then
follow the instructions given below:
IMPORTANT:
DO NOT make any connection to the terminal which is
marked with the letter E or by the safety earth symbol or
coloured green or green-and-yellow.
The wires in the mains lead on this product are coloured
in accordance with the following code:
Blue :
Neutral
Brown :
Live
As these colours may not correspond with the coloured
markings identifying the terminals in your plug proceed as
follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured
black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or coloured
red.
IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1.
Do not remove screws, covers or cabinet.
2.
Do not expose this appliance to rain or moisture.
Caution
STANDBY/ON button!
Disconnect the mains plug to shut the power off completely
(the STANDBY/ON lamp goes off).
The
STANDBY/ON button in any position does not
disconnect the mains line.
· When the unit is on standby, the STANDBY/ON lamp
lights red.
· When the unit is turned on, the STANDBY/ON lamp lights
green.
The power can be remote controlled.
G-1
UX-A52R[B]_SAFETY_f
01.12.4, 7:57 PM
1
G-2
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage,
locate the apparatus as follows:
1 Front:
No obstructions and open spacing.
2 Sides/ Top/ Back:
No obstructions should be placed in the areas shown by
the dimensions below.
3 Bottom:
Place on the level surface. Maintain an adequate air path
for ventilation by placing on a stand with a height of 10 cm
or more.
CAUTION
·
Do not block the ventilation openings or holes.
(If the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able to get
out.)
·
Do not place any naked flame sources, such as lighted
candles, on the apparatus.
·
When discarding batteries, environmental problems
must be considered and local rules or laws governing
the disposal of these batteries must be followed strictly.
·
Do not expose this apparatus to rain, moisture, dripping
or splashing and that no objects filled with liquids, such
as vases, shall be placed on the apparatus.
Front view
Side view
1 cm
15 cm
10 cm
1 cm
15 cm
15 cm
15 cm
15 cm
15 cm
UX-A52R
UX-A52R
UX-A52R[B]_SAFETY_f
01.12.4, 7:57 PM
2
G-3
IMPORTANT FOR LASER PRODUCTS
REPRODUCTION OF LABELS
1. CLASS 1 LASER PRODUCT
2. DANGER: Invisible laser radiation when open and
interlock failed or defeated. Avoid direct exposure to beam.
3. CAUTION: Do not open the top cover. There are no user
serviceable parts inside the Unit; leave all servicing to
qualified service personnel.
1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE
2 WARNING LABEL, PLACED INSIDE THE UNIT
CLASS
1
LASER
PRODUCT
UX-A52R[B]_SAFETY_f
01.12.4, 7:57 PM
3
G-4
SAFETY INSTRUCTIONS
"SOME DOS AND DON'TS ON THE SAFE USE OF EQUIPMENT"
This equipment has been designed and manufactured to meet international safety standards but, like any electrical
equipment, care must be taken if you are to obtain the best results and safety is to be assured.
Do read the operating instructions before you attempt to use the equipment.
Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between
pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and with-
draw the mains plug when making or changing connections.
Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.
Do be careful with glass panels or doors on equipment.
DON'T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in any
way switch off, withdraw the mains plug and consult your dealer.
DON'T remove any fixed cover as this may expose dangerous voltages.
DON'T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for unat-
tended operation or has a standby mode.
Switch off using the switch on the equipment and make sure that your family know how to do this.
Special arrangements may need to be made for infirm or handicapped people.
DON'T use equipment such as personal stereos or radios so that you are distracted from the requirements of traffic
safety. It is illegal to watch television whilst driving.
DON'T listen to headphones at high volume as such use can permanently damage your hearing.
DON'T obstruct the ventilation of the equipment, for example with curtains or soft furnishings.
Overheating will cause damage and shorten the life of the equipment.
DON'T use makeshift stands and NEVER fix legs with wood screws -- to ensure complete safety always fit the
manufacturer's approved stand or legs with the fixings provided according to the instructions.
DON'T allow electrical equipment to be exposed to rain or moisture.
ABOVE ALL
-- NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case
-- this could result in a fatal electrical shock.
-- NEVER guess or take chances with electrical equipment of any kind -- it is better to be safe than sorry!
UX-A52R[B]_SAFETY_f
01.12.4, 7:57 PM
4