MICROFILM
RM-V80T
SERVICE MANUAL
REMOTE COMMANDER
SPECIFICATIONS
AEP Model
Operable distance
Approx. 7m (23 ft) (varies depending on the component of
each manufacturer)
Power requirements
Vanadium-Lithium Rechargeable Battery (3.0 V, 50 mAh)
Flexible Hydrogenated Amorphous Silicon Solar Cells
Dimensions
Approx. 74 x 210 x 25 mm (w/h/d)
(3 x 8 x 1 in.)
Mass
Approx. 150 g (5 oz.)
Supplied accessory
Label (1)
Design and specifications are subject to change without notice.
Ver. 1.0
1998.03
2
SECTION 1
GENERAL
This section is extracted from
instruction manual.
3
4
r
WAV0EFORM
1
VOLT/DIV : 1V AC
TIME/DIV : 0.1
µ sec
4.6Vp-p
4MHz
Note:
· All capacitors are in
µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
· All resistors are in
and 1/4 W or less unless otherwise
specified.
·
¢
: internal component.
· U : B+ Line.
· Power voltage is dc 3V and fed with regulated dc power
supply from battery terminal.
· Voltages and waveforms are dc with respect to ground
under no-signal conditions.
: Impossible to measure
· Voltages are taken with a VOM (Input impedance 10 M
).
Voltage variations may be noted due to normal produc-
tion tolerances.
· Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
· Circled numbers refer to waveforms.
2-1. SCHEMATIC DIAGRAM
SECTION 2
DIAGRAMS
RM-V80T
