MANUAL DE INSTRUCCIONES
MANUALE DI INSTRUZIONI
AC POWER ADAPTER/CHARGER
ADAPTATEUR SECTEUR/CHARGEUR DE BATTERIE
ADAPTADOR/CARGADOR DE CA
Thank you for purchasing the JVC AC Power Adapter/Charger. This unit provides DC power for the JVC
Digital Video Camera from a household AC outlet. It can be used to recharge the JVC battery pack for
exclusive use with the JVC Digital Video Camera, and is capable of charging two battery packs
consecutively. To avoid problems and obtain the best results, please read this instruction booklet carefully
before use. Before using as a power adapter, make sure that this unit's model number is the same as that of
the power supply unit specified in the instruction manual of the equipment you wish to power.
When you are not using this unit for a long
period of time, it is recommended that you
disconnect the power cord from AC outlet.
TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN
This unit should be used with AC 110 240 V`
50/60 Hz only.
To prevent electric shocks and fire hazards, do
NOT use any other power source.
To prevent electric shock, do not open the
cabinet. No user serviceable parts inside. Refer
servicing to qualified service personnel.
The rating plate (Serial number plate) is on the
bottom of the unit.
This AC Power Adapter/Charge is for use
exclusively with JVC Digital Camcorders.
·If used near a radio, this unit may interfere
·Prevent inflammables, water and metallic
objects from entering the unit.
·Do not disassemble or modify the unit.
·Do not apply shocks to the unit.
·Do not subject the unit to direct sunlight.
·Avoid using the unit in extremely hot or humid
·Avoid using the unit in places subject to
A WORD ON THE EXCLUSIVE BATTERY PACKS
The battery packs are lithium-ion.
Give attention to the following to make the most
of their characteristics.
For charging: 10°C to 35°C
For operating: 0°C to 40°C
For storing: 10°C to 30°C
Connection to the mains supply in the United
DO NOT cut off the mains plug from this equipment.
If the plug fitted is not suitable for the power points in
your home or the cable is too short to reach a power
point, then obtain an appropriate safety approved
extension lead or consult your dealer.
BE SURE to replace the fuse only with an identical
approved type, as originally fitted, and to replace the
If nonetheless the mains plug is cut off ensure to
remove the fuse and dispose of the plug immediately,
to avoid a possible shock hazard by inadvertent
connection to the mains supply.
If this product is not supplied fitted with a mains plug
then follow the instructions given below:
DO NOT make any connection to the Larger Terminal
coded E or Green. The wires in the mains lead are
coloured in accordance with the following code:
Blue to N (Neutral) or Black
Brown to L (Live) or Red
If these colours do not correspond with the terminal
identifications of your plug, connect as follows:
Blue wire to terminal coded N (Neutral) or coloured
Brown wire to terminal coded L (Live) or coloured
If in doubt -- consult a competent electrician.
CHARGING THE BATTERY PACK
You can charge one battery pack at a time, or two consecutively.
To AC outlet
DC OUT terminal
Slide the battery or batteries in the
opposite direction of the arrow and lift
off. Remember to unplug the AC Adapter/
Charger's power cord from an AC outlet.
Perform charging where the temperature is
between 10° and 35°C. (20°25°C is the ideal
temperature range for charging.) If the
environment is too cold, charging may be
approx. 1 hr.
approx. 3 hrs.*
approx. 3 hrs.*
approx. 6 hrs.*
* When charged at temperatures between 20°
·When charging Battery Packs after a long
storage period, charging time will be longer
than the time indicated above.
BATTERY PACK CHARGING TIME
SUPPLY POWER TO CHARGER
Make sure you unplug the camcorder's
DC cord from the AC Power Adapter/
Plug the AC Adapter/Charger's power
cord into an AC outlet. The power lamp
Attach the battery pack while making sure
its terminal side
1 is in contact with the
indicator side of the battery pack mount
on the AC Power Adapter/Charger.
· The Charger Indicator (1 or 2) begins
blinking to indicate charging has started.
When the charger indicator stops blinking
but stays lit, charging is finished.
· If two batteries are attached to the
charger, they will be charged in the
order that they were attached.