MANUAL DE INSTRUCCIONES
For assistance and information
(United States and Puerto Rico)
To reduce the risk of fire or electric shock, do not expose
this appliance to rain or moisture.
"CAUTION:TO REDUCE THE RISK OF
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Explanation of Graphical Symbols:
The lightning flash with arrowhead
symbol, within an equilateral triangle, is
intended to alert the user to the presence
of uninsulated "dangerous voltage" within
the product's enclosure that may be of
sufficient magnitude to constitute a risk
of electric shock to persons.
The exclamation point within an
equilateral triangle is intended to alert the
user to the presence of important
operating and maintenance (servicing)
accompanying the appliance.
Read these Operating Instructions carefully and completely
before operating the unit. All precautions on this booklet
and on the unit should be strictly followed.
Keep the Operating Instructions for future reference.
Slots and openings in the cabinet and the back or bottom are
provided for ventilation, and to ensure reliable operation of
the unit and to protect it from overheating, these openings
must not be blocked or covered. The openings should never
be blocked by placing the unit on a bed, sofa, rug or other
similar surface. (This unit should never by placed near or over
a radiator or heat register.) This unit should not be placed in a
built-in installation such as a bookcase unless proper
ventilation is provided.
Object and Liquid Entry -- Never push objects of any
kind into this unit through the cabinet slots as they may touch
dangerous voltage points or short-circuit parts that could result
in a fire or electric shock. Never spill liquid of any kind on the
Wall or ceiling mounting -- The unit should not be
mounted on a wall or ceiling, unless specified in the Operating
Power Sources -- This unit should be operated only from
the type of power source indicated on the marking label. If
you are not sure of the type of power supply to your home,
consult your appliance dealer or local power company. To
operate unit on battery power, or other sources, refer to the
Grounding or Polarization -- This unit is provided with a
polarized alternating-current line plug (a plug having one blade
wider than the other). This plug will fit into the power outlet
only one way. This is a safety feature. If you are unable to
insert the plug fully into the outlet, try reversing the plug. If
the plug should still fail to fit, contact your electrician to replace
your obsolete outlet. Do not defeat the safety purpose of the
Power-Cord Protection --- Power-supply cords should
be routed so that they are not likely to be walked on or pinched
by items placed upon or against them, paying particular
attention to cords at plugs, convenience receptacles, and the
point where they exit from the product.
To prevent electric shock or injury, these safety instructions
should be followed in the installation, use and servicing the
Attachments -- Do not use attachments not recommended
by the unit manufacturer as they may result in the risk of fire,
electric shock or injury to persons.
Water and Moisture -- Do not use this unit near water -
for example, near a bathtub, washbowl, kitchen sink, or laundry
tub, in a wet basement, or near a swimming pool, and the
Heat -- Do not use this unit near sources of heat, including
heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures less than 5°C
(41°F) or greater than 35°C (95°F ).
Mounting surface -- Place the unit on a flat, even surface.
Accessories -- Do not place this unit on an unstable cart,
stand, tripod, bracket, or table. The unit may fall, causing
serious injury to a child or an adult, and serious damage to
the appliance. Use only with a cart, stand, tripod, bracket, or
table recommended by the manufacturer, or sold with the unit.
Any mounting of the appliance should follow the
manufacturer's instructions, and should use a mounting
accessory recommended by the manufacturer.
Portable cart -- An appliance and cart
combination should be moved with care.
Quick stops, excessive force, and uneven
surfaces may cause the appliance and cart
combination to overturn.
Ventilation -- The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 15 cm clearance from the rear and the top of the unit,
and 5 cm from the each side.
TABLE OF CONTENTS
PRECAUTION ...................................... 2
PREPARATION .................................... 5
PARTS AND CONTROLS ......................... 8
ADJUSTMENT BEFORE OPERATION ......... 12
PREPARATORY INFORMATION ......... 14
BASIC PLAYBACK ........................ 15
SELECTING TRACKS/CHAPTERS ....... 17
OTHER PLAYBACK MODES .................. 18
DVD FEATURES ........................... 20
STATUS DISPLAY ......................... 22
DOLBY AND DTS SURROUND ................ 23
RADIO ............................................ 25
SOUND ........................................... 27
TIMER ............................................ 28
EXTERNAL EQUIPMENT ....................... 30
CUSTOMIZING DVD SETUP ................... 31
REFERENCE ..................................... 38
Overloading -- Do not allow anything to rest on the power
cord. Do not overload wall outlets and extension cords as
this can result in fire or electric shock. Do not locate this unit
where the cord will be abused by persons walking on it.
Power lines -- An outside antenna system should not be
located in the vicinity of overhead power lines or other electric
light or power circuits, or where it can fall into such power
lines or circuits. When installing an outside antenna system,
extreme care should be taken to keep from touching such
power lines or circuits as contact with them might be fatal.
Outdoor Antenna Grounding -- If an outside antenna or
cable system is connected to the unit, be sure the antenna or
cable system is grounded so as to provide some protection
against voltage surges and built-up static charges. Section
810 of the National Electrical Code, ANSI/NFPA No.70,
provides information with regard to proper grounding of the
mast and supporting structure, grounding of the lead-in wire
to an antenna discharge unit, size of grounding conductors,
location of antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode. See
Antenna Grounding According
to the National Electrical Code
(NEC ART 250 PART H)
NEC-NATIONAL ELECTRICAL CODE
For added protection for this unit receiver during a lightning
storm, or when it is left unattended and unused for long periods
of time, unplug it from the wall outlet and disconnect the
antenna or cable system. This will prevent damage to the unit
due to lightning and powerline surges.
Cleaning -- Unplug this unit from the wall outlet before
cleaning. Do not use liquid cleaners or aerosol cleaners. Use
a damp cloth for cleaning.
Damage Requiring Service
Unplug this unit from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
1)When the power cord or plug is damaged or frayed.
2)If the liquid has been spilled into the unit.
3)If the unit has been exposed to rain or water.
4)If the unit does not operate normally by following the
operating instructions. Adjust only those controls that are
covered by the operating instructions as improper
adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to
restore the unit to normal operation.
5)If the unit has been dropped or the cabinet has been
6)When the unit exhibits a distinct change in performance -
this indicates a need for service.
Do not attempt to service this unit yourself as opening or
removing covers may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel.
Replacement Parts -- When replacement parts are
required, be sure the service technician has used replacement
parts specified by the manufacturer or having the same
characteristics as the original part. Unauthorized substitutions
may result in fire, electric shock or other hazards.
Safety Check -- Upon the completion of any service or
repairs to this unit, ask the service technician to perform safety
checks to determine that the unit is in proper operating
Record the model number and serial number of your set
(found at the rear of your set) below. Refer to them when
contacting your Aiwa dealer.
Model No. _____________________________
Serial No. _____________________________
System and accessories
CX-LDV700 DVD stereo system
SX-L700 Five Surround speaker system (front speakers,
surround speakers, center speaker)
Lithium battery (CR2025)
FM antenna, AM antenna
Connecting cord (DIN 8-pin)
Video connecting cord
Front speakers cord (approx. 4 m / 13 ft.) × 2
Surround speaker cord (with plugs, approx. 8 m / 26 ft.) × 2
The red plug is for the right channel and the white plug is for
the left channel.
Center speaker cord (with an orange plug, approx. 3 m /
10 ft.) × 1
Pedestal × 2
Place the speakers in their proper position. All speakers for a
full 5.1-channel home theater come supplied with your DVD
L&R: Front speakers (marked "FRONT")
C: Center speaker (marked "CENTER")
Place it in the center of the two front speakers, possibly on or
below the TV set.
LS&RS: Surround speakers (marked "REAR")
Place them directly to the side of or slightly behind the listening
area. Align them horizontally, preferably about 1 meter (3 feet)
above ear height.
Place it on the floor close to a wall or in a corner of the room.
To attach the front speaker to the pedestal
To mount the surround speakers on the wall
Mount each speaker on a spot that can hold its weight.
AIWA disclaims any responsibility for injury to persons
or other accidents caused by not fitting the surround
speakers properly or if the place of the installation is not
·Either of the two front speakers can be used as the right or
the left one; likewise for the surround speakers.
·Do not place the left and right front speakers close to the TV
set, as doing so may cause picture noise.
·Sound output from the center and the surround speakers is
only available when the Dolby or the DTS surround system
is activated with the appropriate setting.
Placing the main unit
Allow 15 cm (6 in.) clearance from the top of the unit for
movement of the disc compartment lid.
Attaching the anti-skid patches
To prevent the surround and center speakers from slipping,
attach the supplied anti-skid patches to the bottom of the
speakers. Use 3 patches for each of these speakers.