background image
MENU
ECO
SDM-S75A: U/C, AEP, CH
SDM-S75D: U/C, AEP, CH
SDM-S75E: U/C
SDM-S75F: AEP
SDM-S95A: U/C, AEP
SDM-S95D: U/C, AEP
SDM-S95E: U/C
SDM-S95F: AEP, CH
Service Manual
TFT LCD COLOR COMPUTER DISPLAY


background image
CONTENTS
Page
PRECAUTIONS
3
SPECIFICATIONS
4
TIMING CHART
5
SIGNAL CONNECTOR PIN
6
OPERATING INSTRUCTIONS
7
SERVICE MODE
8
WIRING DIAGRAM
9
DISASSEMBLY
10
ADJUSTMENT
11
EXPLODED VIEW
12
REPLACEMENT PARTS LIST
1314
SDM-S75A,D,E,F/ SDM-S95A,D,E,F (E)
-2 -


background image
PRECAUTION
WARNING FOR THE SAFETY-RELATED COMPONENT.
· There are some special components used in LCD
monitor that are important for safety. These parts
are marked on the schematic diagram and the
replacement parts list. It is essential that these
critical
parts
should
be
replaced
with
the
manufacturer's specified parts to prevent electric
shock, fire or other hazard.
· Do not modify original design without obtaining written
permission from manufacturer or you will void the
original parts and labor guarantee.
· If you want to replace with the new backlight
(CCFL) or inverter circuit, must disconnect the
AC adapter because high voltage appears at
inverter circuit about 650Vrms.
TAKE CARE DURING HANDLING THE LCD MODULE
WITH BACKLIGHT UNIT.
· Handle with care wires or connectors of the
inverter circuit. If the wires are pressed cause
short and may burn or take fire.
· Must mount the module using mounting holes
arranged in four corners.
· Do not press on the panel, edge of the frame strongly
or electric shock as this will result in damage to the
screen.
Leakage Current Hot Check Circuit
· Do not scratch or press on the panel with any sharp
objects, such as pencil or pen as this may result in
damage to the panel.
· Protect the module from the ESD as it may damage
the electronic circuit (C-MOS).
· Make certain that treatment person's bodies are
grounded through wrist band.
· Do not leave the module in high temperature and in
areas of high humidity for a long time.
· The module not is exposed to the direct sunlight.
· Avoid contact with water as it may a short circuit
within the module.
· If the surface of panel becomes dirty, please wipe it
off with a soft material. (Cleaning with a dirty or
rough cloth may damage the panel.)
SDM-S75A,D,E,F/ SDM-S95A,D,E,F (E)
3


background image
SPECIFICATIONS
1. LCD CHARACTERISTICS
Type
: TFT Color LCD Module
Active Display Area : 17 inch- S75A/D/E/F
: 19 inch- S95A/D/E/F
Pixel Pitch
: 0.264 (H) x 0.264 (V) S75A/D/E/F
: 0.294 (H) x 0.294 (V) S95A/D/E/F
Size
: 358.5(H) x 296.5(V) x 17.0(D)
S75A/D/E/F
: 404.2(H) x 332(V) x 20.0(D)
S95A/D/E/F
Color Depth
: 16.2M Colors- S75A/D/E/F
: 16.7M Colors- S95A/D/E/F
Electrical Interface
: LVDS
Surface Treatment
: Haze 25%, Hard-coating (3H)
Operating Mode
: Normally White
Backlight Unit
: 4-CCFL
2. OPTICAL CHARACTERISTICS
2-1. Viewing Angle by Contrast Ratio > 10
SDM-S75A/D/E/F-LPL TN
Left:+60°min., +70°(Typ), Right:+60° min.,+70°(Typ)
Top:+45° min.,+60°(Typ), Bottom:+50°min.,+60°(Typ)
SDM-S75A/D/E/F-AUO
Left:+60° min.,+70°(Typ), Right:+60° min.,+70°(Typ)
Top:+60° min.,+70°(Typ), Bottom:+50°min.,+60°(Typ)
SDM-S95A/D/F
Left:+85°min., Right:+85° min.
Top:+85°min., Bottom:+85° min.
SDM-S95E
Left:+60°min., Right:+60°min.
Top:+85°min., Bottom:+85°min.
2-2. Luminance:
300(Typ)-SDM-S75A/D/E/F
250(Typ)-SDM-S95A/D/E/F
2-3. Contrast Ratio:
450:1(Typ)-SDM-S75A/D/E/F
700:1(Typ)-SDM-S95A/D/E/F
3. SIGNAL (Refer to the Timing Chart)
3-1. Sync Signal
Type : Separate Sync, Composite Sync
SOG (Sync On Green), Digital
3-2. Video Input Signal
1) Type: R, G, B Analog
2) Voltage Level: 0~0.71 V
a) Color 0, 0: 0 Vp-p
b) Color 7, 0: 0.467 Vp-p
c) Color 15, 0: 0.714 Vp-p
3) Input Impedance : 75
3-3. Operating Frequency
Analog
Digital
Horizontal:
28 ~ 80kHz
28 ~ 64kHz
Vertical:
48 ~ 75Hz
60Hz
Dot Clock:
< 135MHz
< 108MHz
4. Max. Resolution
Analog: 1280 x 1024 /75Hz
Digital: 1280 x 1024 /60Hz
5. POWER SUPPLY
5-1. Power: AC 100~240V, 50/60Hz, 1.0A
5-2. Power Consumption
6. ENVIRONMENT
6-1. Operating Temperature:
5°C~35°C (41°F~95°F)
6-2. Relative Humidity:
10%~80% (Non-condensing)
7. DIMENSIONS (with TILT/SWIVEL)
SDM-S75A/D
Width: 369 mm (14.53'')
Depth: 225 mm (8.86'')
Height: 369 mm (14.53'')
SDM-S75E/F
Width: 369 mm (14.53'')
Depth: 253 mm (9.96'')
Height: 393.5 mm ~ 503.5 mm (15.49'' ~ 19.82'')
SDM-S95A/D
Width: 414 mm (16.30'')
Depth: 277.5 mm (10.93'')
Height: 439.5 mm (17.30'')
SDM-S95E/F
Width: 414 mm (16.30'')
Depth: 277.5 mm (10.93'')
Height: 409.5 mm ~ 519.5 mm (16.12'' ~ 20.45'')
8. WEIGHT (with TILT/SWIVEL)
SDM-S75A/D
Net. Weight: 6.30 kg (13.89 lbs)
Gross Weight: 8.30 kg (18.30 lbs)
SDM-S75E/F
Net. Weight: 7.40 kg (16.32 lbs)
Gross Weight: 9.90 kg (21.83 lbs)
SDM-S95A/D
Net. Weight: 8.60 kg (18.96 lbs)
Gross Weight: 11.50 kg (25.36 lbs)
SDM-S75A,D,E,F/ SDM-S95A,D,E,F (E)
4


background image
SDM-S75A,D,E,F/ SDM-S95A,D,E,F (E)
5
SDM-S75A,D,E,F/ SDM-S95A,D,E,F (E)
5