background image
4-084-256-12(1)
© 2001 Sony Corporation
TFT LCD Color
Computer Display
Operating Instructions
Mode d'emploi
Bedienungsanleitung
Manual de instrucciones
Istruzioni per l'uso
GB
G:\_Upload\4084256121\4084256121SDMM61AEP\01COV-SDMM61AEP\01GB01COV-UC.fm
masterpage:Right
SDM-M61
4-084-256-12 (1)
DE
FR
IT
ES
SDM-M61
01GB01COV-UC.book Page 1 Monday, July 2, 2001 2:25 PM


background image
2
G:\_Upload\4084256121\4084256121SDMM61AEP\01COV-SDMM61AEP\01GB02GET-UC.fm
masterpage:Left
SDM-M61
4-084-256-12 (1)
Owner's Record
The model and serial numbers are located at the rear of the unit.
Record these numbers in the spaces provided below. Refer to them
whenever you call upon your dealer regarding this product.
Model No.
Serial No.
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
Dangerously high voltages are present inside the
unit. Do not open the cabinet. Refer servicing to
qualified personnel only.
FCC Notice
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
­ Reorient or relocate the receiving antenna.
­ Increase the separation between the equipment and receiver.
­ Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
­ Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
WARNING
NOTICE
This notice is applicable for USA/Canada only.
If shipped to USA/Canada, install only a UL LISTED/CSA
LABELLED power supply cord meeting the following
specifications:
SPECIFICATIONS
Plug Type
Nema-Plug 5-15p
Cord
Type SVT or SJT, minimum 3
× 18 AWG
Length
Maximum 15 feet
Rating
Minimum 7 A, 125 V
NOTICE
Cette notice s'applique aux Etats-Unis et au Canada
uniquement.
Si cet appareil est exporté aux Etats-Unis ou au Canada, utiliser
le cordon d'alimentation portant la mention UL LISTED/CSA
LABELLED et remplissant les conditions suivantes:
SPECIFICATIONS
Type de fiche
Fiche Nema 5-15 broches
Cordon
Type SVT ou SJT, minimum 3
× 18 AWG
Longueur
Maximum 15 pieds
Tension
Minimum 7 A, 125 V
As an
ENERGY STAR Partner, Sony
Corporation has determined that this
product meets the
ENERGY STAR
guidelines for energy efficiency.
If you have any questions about this product, you may call:
Sony Customer Information Center
1-800-222-SONY (7669)
or write to:
Sony Customer Information Center
1 Sony Drive, Mail Drop #T1-11, Park Ridge, NJ 07656
Declaration of Conformity
Trade Name:
SONY
Model No.:
SDM-M61
Responsible Party:
Sony Electronics Inc.
Address:
680 Kinderkamack Road,Oradell,NJ 07649
USA
Telephone No.:
201-930-6972
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This monitor complies with the
TCO'99 guidelines.
01GB01COV-UC.book Page 2 Monday, July 2, 2001 2:25 PM


background image
3
Table of Contents
GB
G:\_Upload\4084256121\4084256121SDMM61AEP\02GB-SDMM61AEP\01GB02BAS-UCTOC.fm
masterpage:Toc.master
SDM-M61
4-084-256-12(1)
· Macintosh is a trademark licensed to
Apple Computer, Inc., registered in the
U.S.A. and other countries.
· Windows is registered trademark of
Microsoft Corporation in the United
States and other countries.
· IBM PC/AT and VGA are registered
trademarks of IBM Corporation of the
U.S.A.
· VESA and DDC are trademarks of the
Video Electronics Standards
Association.
·
ENERGY STAR is a U.S. registered
mark.
· All other product names mentioned
herein may be the trademarks or
registered trademarks of their respective
companies.
·Furthermore, "
"and ""are not
mentionedineachcaseinthis manual.
Precautions... ... ... ... ... .... ... ... ... .... ... ... ... ... 4
Identifyingparts and controls . .... ... ... ... .... ... ... ... ... 5
Setup .......... ........... .......... ...........7
Step 1: Connect the display to your computer . .... ... ... ... ... 7
Step 2: Check the digital/analog select switch . .... ... ... ... ... 7
Step 3: Connect the audio cord . . . . . . . . . . . . .... ... ... ... ... 8
Step 4: Connect the power cord... ... ... ... .... ... ... ... ... 8
Step 5: Secure thecords andclose the back cover. ... ... ... ... 8
Step 6: Turn on themonitor and computer ... .... ... ... ... ... 9
Using the stereo speakers ... .... ... ... ... .... ... ... ... ... 9
Selectingthe inputsignal . ... .... ... ... ... .... ... ... ... ... 9
Adjustingthe tilt and height... .... ... ... ... .... ... ... ... .. 10
CustomizingYour Monitor ... .......... ..........11
Navigating themenu . . ... ... .... ... ... ... .... ... ... ... .. 11
Adjustingthe contrast (CONTRAST) .. ... ... .... ... ... ... .. 12
Adjusting the black level of an image (BRIGHTNESS). . . . . . . . . . 12
Eliminating flicker or blurring (PHASE/PITCH)
(Analog RGBsignal only) . ... .... ... ... ... .... ... ... ... .. 13
Adjusting the picture position (H CENTER/V CENTER)
(Analog RGBsignal only) . ... .... ... ... ... .... ... ... ... .. 13
Adjustingthe color temperature (COLOR) . ... .... ... ... ... .. 14
Changing the picture size according to the signal (ZOOM) . . . . . . 15
Smoothing the picture (SMOOTHING) . ... ... .... ... ... ... .. 15
Changing the menu's position (MENU POSITION) . . . . . . . . . . . . 15
Additionalsettings. ... ... ... .... ... ... ... .... ... ... ... .. 16
Technical Features ......... .......... ..........17
Power saving function. ... ... .... ... ... ... .... ... ... ... .. 17
Automatic picture quality adjustment function . .... ... ... ... .. 17
Troubleshooting. ........... .......... ..........18
On-screenmessages . ... ... .... ... ... ... .... ... ... ... .. 18
Troublesymptoms and remedies .. ... ... ... .... ... ... ... .. 19
Self-diagnosis function . . . . . . .... ... ... ... .... ... ... ... .. 21
Specifications... ........... .......... ..........21
Appendix ...... ........... .......... ...........i
Preset mode timing table . ... .... ... ... ... .... ... ... ... ....i
TCO'99 Eco-document .. ... .... ... ... ... .... ... .Back Cover
01GB02BAS-UC.book Page 3 Monday, July 2, 2001 2:26 PM


background image
4
G:\_Upload\4084256121\4084256121SDMM61AEP\02GB-SDMM61AEP\01GB02BAS-UC.fm
masterpage:Left
SDM-M61
4-084-256-12(1)
Precautions
Warning on power connections
· Use the supplied power cord. If you use a different power cord,
be sure that it is compatible with your local power supply.
For the customers in the U.S.A.
If you do not use the appropriate cord, this monitor will not
conform to mandatory FCC standards.
For the customers in the UK
If you use the monitor in the UK, be sure to use the appropriate
UK power cord.
For use only with AC adapter, SONY AC-V018
Installation
Do not install or leave the monitor:
· In places subject to extreme temperatures, for example near a
radiator, heating vent, or in direct sunlight. Subjecting the
monitor to extreme temperatures, such as in an automobile
parked in direct sunlight or near a heating vent, could cause
deformations of the casing or malfunctions.
· In places subject to mechanical vibration or shock.
· Near any equipment that generates a strong magnetic field,
such as a TV or various other household appliances.
· In places subject to inordinate amounts of dust, dirt, or sand, for
example near an open window or an outdoor exit. If setting up
temporarily in an outdoor environment, be sure to take
adequate precautions against airborne dust and dirt. Otherwise
irreparable malfunctions could occur.
Handling the LCD screen
· Do not leave the LCD screen facing the sun as it can damage
theLCD screen. Takecarewhenyou place themonitor by a
window.
· Do not push on or scratch the LCD screen. Do not place a heavy
object on the LCD screen. This may cause the screen to lose
uniformity or cause LCD panel malfunctions.
· If the monitor is used in a cold place, a residual image may
appear on the screen. This is not a malfunction. The screen
returns to normal as the temperature rises to a normal operating
level.
· If a still picture is displayed for a long time, a residual image
may appear for a while. The residual image will eventually
disappear.
· The LCD panel becomes warm during operation. This is not a
malfunction.
About the built-in stereo speakers
Be sure to keep magnetic recording equipment, tapes, and floppy
discs away from the speaker's opening as the speakers generate a
magnetic field. This magnetic field may affect data stored on
magnetic tapes and discs.
Note on the LCD (Liquid Crystal Display)
Please note that the LCD screen is made with high-
precision technology. However, black points or bright
points of light (red, blue, or green) may appear
constantly on the LCD screen, and irregular colored
stripes or brightness may appear on the LCD screen.
This is not malfunction.
(Effective dots: more than 99.99%)
Replacement of the fluorescent tube
A specially designed fluorescent tube is installed as the lighting
apparatus for this monitor. If the screen becomes dark, unstable,
or does not turn on, replace the fluorescent tube with a new one.
Consult your Sony dealer when replacing the fluorescent tube.
Maintenance
· Be sure to unplug the power cord from the power outlet before
cleaning your monitor.
· Clean theLCD screen with asoft cloth. If you useaglass
cleaning liquid, do not use any type of cleaner containing an
anti-static solution or similar additive as this may scratch the
LCD screen's coating.
· Clean the cabinet, panel, and controls with a soft cloth lightly
moistened with a mild detergent solution. Do not use any type
of abrasive pad, scouring powder, or solvent, such as alcohol or
benzine.
· Do not rub, touch, or tap the surface of the screen with sharp or
abrasive items such as a ballpoint pen or screwdriver. This type
of contact may result in a scratched picture tube.
· Note that material deterioration or LCD screen coating
degradation may occur if the monitor is exposed to volatile
solvents such as insecticide, or if prolonged contact is
maintained with rubber or vinyl materials.
Transportation
· Disconnect all cables from the monitor and grasp the support
and base sections of the display stand firmly with both hands
when transporting. If you drop the monitor, you may be injured
or the monitor may be damaged.
· When you transport this monitor for repair or shipment, use the
original carton and packing materials.
Disposal of the monitor
· Do not dispose of this monitor with general
household waste.
· The fluorescent tube used in this monitor contains
mercury. Disposal of this monitor must be carried out
in accordance to the regulations of your local
sanitation authority.
The equipment should be installed near an easily accessible outlet.
Example of plug types
for 100 to 120 V AC
for 200 to 240 V AC
for 240 V AC only
01GB02BAS-UC.book Page 4 Monday, July 2, 2001 2:26 PM


background image
5
GB
G:\_Upload\4084256121\4084256121SDMM61AEP\02GB-SDMM61AEP\01GB02BAS-UC.fm
masterpage:Right
SDM-M61
4-084-256-12(1)
Identifying parts and controls
See the pages in parentheses for further details.
1 1 (Power) switch and indicator (pages 9, 17, 21)
This switch turns the display on and off.
The power indicator lights up in green when the display is
turned on, and either flashes in green and orange, or lights up
in orange when the monitor is in power saving mode.
2 MENU button (pages 11, 12)
This button displays the main menu.
3
6 (contrast) button (page 12)
This button displays the CONTRAST menu.
4
8 (brightness) button (page 12)
This button displays the BRIGHTNESS menu.
5 2 (volume) +/­ and
M(+)/m(­) buttons (pages 9, 12)
These buttons display the VOLUME menu and function as
the
M(+)/m(­) buttons when selecting the menu items and
making adjustments.
6 INPUT and OK button, and indicator (pages 9, 12)
This button selects the INPUT1 (DVI-I (digital/analog RGB)
connector) or INPUT2 (HD15 (analog RGB) connector)
video input signal. The input signal and corresponding input
indicator change each time you press this button.
This button also functions as the OK button when displaying
the menu on the screen.
7 Stereo speakers (page 9)
This outputs the audio signals as sound.
8 Headphones jack (page 9)
This jack outputs audio signals to the headphones.
9 Security Lock Hole
The security lock hole should be applied with the Kensington
Micro Saver Security System.
Micro Saver Security System is a trademark of Kensington.
Front of the LCD display
Side view of the LCD display
Rear of the display stand
MENU
OK
INPUT
1
2
(continued)
01GB02BAS-UC.book Page 5 Monday, July 2, 2001 2:26 PM