SERVICE MANUAL
Ver. 2-2004J
Revision History
Lineup: PCV-RS710G
PCV-RS700C
PCV-RS700CB
PCV-RS700CG
PCV-RS700CGP
PCV-RS700CP
PCV-RS712
PCV-RS720G
PCV-RS724G
PCV-RS726G
For American Area
US Model
Canadian Model
9-876-524-02
PERSONAL COMPUTER VAIO
PCV-RS Series
1
1
1
1
1
1
1
1
1
2
PCV-RS Series (AM)
Confidential
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according
to the manufacturer's instructions.
Service and Inspection Precautions
1. Obey precautionary markings and instructions
Labels and stamps on the cabinet, chassis, and components identify areas requiring special precau-
tions. Be sure to observe these precautions, as well as all precautions listed in the operating manual
and other associated documents.
2. Use designated parts only
The set's components possess important safety characteristics, such as noncombustibility and the
ability to tolerate large voltages. Be sure that replacement parts possess the same safety characteris-
tics as the originals. Also remember that the (0 mark, which appears in circuit diagrams and parts
lists, denotes components that have particularly important safety functions; be extra sure to use only
the designated components.
3. Always follow the original design when mounting parts and routing wires
The original layout includes various safety features, such as inclusion of insulating materials (tubes
and tape) and the mounting of parts above the printer board. In addition, internal wiring has been
routed and clamped so as to keep it away from hot or high-voltage parts. When mounting parts or
routing wires. therefore, be sure to duplicate the original layout.
4. Inspect after completing service
After servicing, inspect to make sure that all screws, components, and wiring have been returned to
their original condition. Also check the area around the repair location to ensure that repair work has
caused no damage, and confirm safety.
5. When replacing chip components...
Never reuse components. Also remember that the negative side of tantalum capacitors is easily dam-
aged by heat.
6. When handling flexible print boards...
· The temperature of the soldering-iron tip should be about 270
°C.
· Do not apply the tip more than three times to the same pattern.
· Handle patterns with care; never apply force.
Caution: Remember that hard disk drives are easily damaged by vibration. Always handle with
care.
Information in this document is subject to change without notice.
Sony, VAIO and CLIE are trademarks or registered trademarks of Sony. Microsoft, Windows, Windows
Media, Outlook, Bookshelf and other Microsoft products are trademarks or registered trademarks of
Microsoft Corporation in the United States and other countries.
The word Bluetooth and the Bluetooth logo are trademarks of Bluetooth SIG, Inc. AMD, the AMD
logo, other AMD product names and combinations thereof are trademarks of Advanced Micro Devices,
Inc. Intel Inside logo, Pentium and Celeron are trademarks or registered trademarks of Intel
Corporation.Transmeta, the Transmeta logo, Crusoe Processor, the Crusoe logo and combinations
thereof are trademarks of Transmeta Corporation in the USA and other countries. Graffiti, HotSync,
PalmModem, and Palm OS are resistered trademarks, and the Hotsync logo and Palm are trademarks
of Palm, Inc. or its subsidiaries. (M) and Motrola are trademarks of Motrora, Inc. Other Motrola
products and services with (R) mark like Dragomball are the trademarks of Motrola, Inc.
All other names of systems, products and services in this manual are trademarks or registered trademarks
of their respective owners.
In this manual, the (TM) or (R) mark are not specified.
1-1
PCV-RS Series (AM)
Confidential
SECTION 1
EXPLODED VIEWS
NOTE:
· The parts listed here are for service, and therefore they may be different from the
parts shown in circuit diagrams or used in the set.
· The parts with which the
mark stuck to the Ref. No. in exploded views are parts
to be careful to disassembly or assembly.
Please refer to "SECTION 2 INFORMATIONS ABOUT DISASSEMBLY AND AS-
SEMBLY" for details.
Les composants identifiés par une
marque 0 sont critiquens pour la
sécurité.
Ne les remplacer que par une pièce
portant le numéro spécifié.
The components identified by
mark 0 or dotted line with mark
0 are critical for safety.
Replace only with part number
specified.
51
152
152
11
not supplied
CHASSIS SECTION
1-5
BOARD SECTION
1-4
DRIVE SECTION
1-3
COVER SECTION
1-2
ACCESSORIES
1-6
BASIC LIST
1-7
SUBSTITUTION LIST
1-10
1-2
PCV-RS Series (AM)
Confidential
·COVER SECTION
73
152
78
82
83
77
94
97
96
84
1-3
PCV-RS Series (AM)
Confidential
· DRIVE SECTION
152
152
11
23
22
21
152
53
56
56
151
151
151
not supplied
51
51