background image
English
2000K11XX-1
Printed in USA
9-872-166-11
© 2000 Sony Corporation
PNC Planning & Control Dept. [SODP]
PCGA-CDRW52
SERVICE MANUAL
CD-RW DRIVE
US Model
Canadian Model
Illust : PCGA-CDRW52
This manual and the constituent data may not be
replicated, copied nor reprinted in whole or in part
without prior written authorization of Sony Corporation.
Sony Corporation
Information Technology Company
-- 28 --
9-872-166-11
PCGA-CDRW52 (UC)
PCGA-CDR
W52
(UC
)
2000K11XX-1
9-872-166-11
SPECIFICATIONS
Disc
Compatible discs
·
CD-RW (Not support High Speed CD-RW.)
·
CD-R
·
CD-ROM
·
CD-ROM XA
·
Photo CD (multisession)
·
CD-DA (music CD)
·
Video CD
·
CD Extra (CD+)
·
CD TEXT
·
Electronic Book
Disc diameter: 43/4 in. (12 cm), 3 in. (8 cm) (reading only)
Drive performance
Data transfer rate1)
Max : 24x speed (reading CD-ROM/CD-R)
: 14x speed (reading CD-RW)
: 8x speed (writing CD-R)
: 4x speed (writing CD-RW)
(1x speed=150 KB/s)
Access time
Average (1/3 stroke): 150 ms
Interface card
Interface: Conforms to PCMCIA 2.1/JEIDA 4.2
Card type: PCMCIA Type II (Conforms to CardBus/
16 bit mode)
AC adapter
AC-CDR51 (U.S.A./Canada)
Power requirements
100-240V AC, adjustable, 50/60 Hz
Power consumption
15W max.
Output voltage and current
10 Vmax., 1.5 A
1) The maximum data
transfer rate varies with
the notebook
computer`s
performance.
Other Specifications
Power source
DC IN connector: 10 V
Connecting the supplied AC adapter supplies power
from an AC outlet.
Power consumption
Approx. 6 W (reading)
Approx. 5 W (writing)
Operating temperature
41
°F to 95°F (5°C to 35°C)
(temperature gradient less than 18
°F(10°C)/hour)
Operating humidity
20% to 80% (not condensed),
provided that humidity is less than 65% at 95
°F(35°C)
(hygrometer reading of less than 84
°F(29°C))
Storage temperature
-4
°F to 140°F (-20°C to 60°C)
(temperature gradient less than 18
°F(10°C)/hour)
Storage humidity
10% to 90% (not condensed),
provided that humidity is less than 20% at
140
°F(60°C)
(hygrometer reading of less than 95
°F(35°C))
Dimensions
Approx. 53/4 x 11/16 x 61/8 inches (Approx. 144 x 26 x
153mm) (w/h/d)
Mass
Approx. 20.5 oz. (580 g) (drive only)
Design and specifications are subject to change without
notice.


background image
Information in this document is subject to change without
notice.
Sony and VAIO are trademarks of Sony. Intel logo and Intel Inside
logo are registered trademarks of Intel Corporation. Pentium
MMX is a trademarks of Intel Corporation. Microsoft, MS-DOS,
Windows, the Windows 95 and Windows 98 logo are trademarks
of Microsoft Corporation.
All other trademarks are trademarks or registered trademarks of
their respective owners. Other trademarks and trade names may
be used in this document to refer to the entitles claiming the
marks and names or their produces. Sony Corporation disclaims
any proprietary interest in trademarks and trade names other than
its own.
1. Obey precautionary markings and
instructions
Labels and stamps on the cabinet, chassis, and components iden-
tify areas requiring special precautions. Be sure to observe these
precautions, as well as all precautions listed in the operating
manual and other associated documents.
2. Use designated parts only
The set's components possess important safety characteristics,
such as noncombustibility and the ability to tolerate large
voltages. Be sure that replacement parts possess the same safety
characteristics as the originals. Also remember that the (
mark,
which appears in circuit diagrams and parts lists, denotes com-
ponents that have particularly important safety functions; be extra
sure to use only the designated components.
3. Always follow the original design
when mounting parts and routing wires
The original layout includes various safety features, such as in-
clusion of insulating materials (tubes and tape) and the mount-
ing of parts above the printer board. In addition, internal wiring
has been routed and clamped so as to keep it away from hot or
high-voltage parts. When mounting parts or routing wires. there-
fore, be sure to duplicate the original layout.
Caution Markings for Lithium/Ion Battery - The following or
similar texts shall be provided on battery pack of equipment or
in both the operating and the service instructions.
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by
the manufacturer. Discard used batteries according to the manu-
facturer's instructions.
CAUTION: The battery pack used in this device may present a
fire or chemical burn hazard if mistreated. Do not disassemble,
heat above 100°C (212°F) or incinerate.
Dispose of used battery promptly.
Keep away from children.
4. Inspect after completing service
After servicing, inspect to make sure that all screws, compo-
nents, and wiring have been returned to their original condition.
Also check the area around the repair location to ensure that
repair work has caused no damage, and confirm safety.
5. When replacing chip components...
Never reuse components. Also remember that the negative side
of tantalum capacitors is easily damaged by heat.
6. When handling flexible print boards...
· The temperature of the soldering-iron tip should be about 270C.
· Do not apply the tip more than three times to the same pattern.
· Handle patterns with care; never apply force.
Caution: Remember that hard disk drives are easily damaged
by vibration. Always handle with care.
Service and Inspection Precautions
-- 2 --
PCGA-CDRW52 (UC)
Confidential


background image
PCGA-CDRW52 (UC)
Confidential
-- 3 --
TABLE OF CONTENTS
CHAPTER 1.
REMOVAL
1-1.
Flowchart ....................................................................................................... 1-1
1-2.
Electric Parts Arrangement Diagram ............................................................. 1-1
1-3.
Removal ......................................................................................................... 1-2
1. Cabinet (Upper) Assy (CD-RW) ............................................................... 1-2
2. Card Assy, PC ........................................................................................... 1-2
3. IFX-81 Board ............................................................................................ 1-3
4. Bezel Assy (CD-RW), Drive/CD-RW Drive ............................................. 1-3
5. IFX-79 Board ............................................................................................ 1-4
(to 1-4)
CHAPTER 2.
DIAGRAMS
2-1.
Block Diagram .............................................................................................. 2-1
2-2.
Printed Wired Boards .................................................................................... 2-1
2-2-1. IFX-77 Board .................................................................................... 2-1
2-2-2. IFX-79 Board .................................................................................... 2-2
2-2-3. IFX-81 Board .................................................................................... 2-2
2-3.
Schematic Diagram ....................................................................................... 2-3
2-3-1. IFX-77 ............................................................................................... 2-3
2-3-2. IFX-79 ............................................................................................... 2-5
2-3-3. IFX-81 ............................................................................................... 2-7
(to 2-8)
CHAPTER 3.
EXPLODED VIEW AND PARTS LIST
3-1.
Main Unit ...................................................................................................... 3-1
3-2.
Electrical Parts List ....................................................................................... 3-2
3-3.
Semiconductor Pin Assignments ................................................................... 3-3
(to 3-8)


background image


background image
PCGA-CDRW52 (UC)
Confidential
1-1
CHAPTER 1.
REMOVAL
1-1. Flowchart
· Page x-x indicatcs the page for the topic.
1-2. Electric Parts Arrangement Diagram
POWER
OFF
Cabinet (Upper)
Assy (CD-RW)
Card Assy,
PC
IFX-81
Board
Bezel Assy
(CD-RW), Drive
IFX-79
Board
CD-RW Drive
(8X UJDA330)
P1-2
P1-2
P1-3
P1-4
P1-3
P1-3
Card Assy, PC
CD-RW Drive (8X UJDA330)
IFX-81 Board
IFX-79 Board
Bezel Assy (CD-RW), Drive