background image
DIGITAL PHOTO PRINTER
DPP-SV88
SERVICE MANUAL
Volume 1 1st Edition (Revised 1)


background image
DPP-SV88 V1
CLASS 1
LASER PRODUCT
LASER KLASSE 1
PRODUKT
This Electrical to Optical Converter is classified as a
CLASS 1 LASER PRODUCT.
The CLASS 1 LASER PRODUCT label is located on the
laser protective housing inside the enclosure.
Laser Diode Properties
Material
: GaAlAs
Wave length
: 780-787 nm
Emission duration : 86 nsec.
Laser output power: 80 mW
! WARNING
This manual is intended for qualified service personnel only.
To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so. Refer all servicing to
qualified service personnel.
! WARNUNG
Die Anleitung ist nur für qualifiziertes Fachpersonal bestimmt.
Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden. Um die
Gefahr eines elektrischen Schlages, Feuergefahr und Verletzungen zu vermeiden, sind bei
Wartungsarbeiten strikt die Angaben in der Anleitung zu befolgen. Andere als die angegeben
Wartungsarbeiten dürfen nur von Personen ausgeführt werden, die eine spezielle Befähigung
dazu besitzen.
! AVERTISSEMENT
Ce manual est destiné uniquement aux personnes compétentes en charge de l'entretien. Afin
de réduire les risques de décharge électrique, d'incendie ou de blessure n'effectuer que les
réparations indiquées dans le mode d'emploi à moins d'être qualifié pour en effectuer d'autres.
Pour toute réparation faire appel à une personne compétente uniquement.


background image
DPP-SV88 V1
1 (P)
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer's instructions.
Vorsicht!
Explosionsgefahr bei unsachgemäßem Austausch
der Batterie.
Ersatz nur durch denselben oder einen vom
Hersteller empfohlenen ähnlichen Typ. Entsorgung
gebrauchter Batterien nach Angaben des
Herstellers.
ATTENTION
Il y a danger d'explosion s'il y a remplacement
incorrect de la batterie.
Remplacer uniquement avec une batterie du même
type ou d'un type équivalent recommandé par le
constructeur.
Mettre au rebut les batteries usagées conformément
aux instructions du fabricant.
ADVARSEL!
Lithiumbatteri-Eksplosionsfare ved fejlagtig
håndtering.
Udskiftning må kun ske med batteri
af samme fabrikat og type.
Levér det brugte batteri tilbage til leverandøren.
ADVARSEL
Lithiumbatteri - Eksplosjonsfare.
Ved utskifting benyttes kun batteri som
anbefalt av apparatfabrikanten.
Brukt batteri returneres
apparatleverandøren.
VARNING
Explosionsfara vid felaktigt batteribyte.
Använd samma batterityp eller en likvärdig typ
som rekommenderas av apparattillverkaren.
Kassera använt batteri enligt gällande
föreskrifter.
VAROITUS
Paristo voi räjähtää jos se on virheellisesti
asennettu.
Vaihda paristo ainoastaan laitevalmistajan
suosittelemaan tyyppiin.
Hävitä käytetty paristo valmistajan ohjeiden
mukaisesti.


background image


background image
1
DPP-SV88 V1
Table of Contents
Manual Structure
Purpose of this manual .............................................................................................. 3
Related manuals ......................................................................................................... 3
1. Service Information
1-1.
Main Parts Location .................................................................................... 1-1
1-1-1.
Main Block Location .................................................................. 1-1
1-1-2.
Board Location ........................................................................... 1-1
1-2.
Removal and Installation of Cabinet ........................................................... 1-1
1-2-1.
Upper Cabinet Assembly ........................................................... 1-1
1-2-2.
Front Panel Assembly ................................................................ 1-2
1-3.
Sensor Arrangement and Functional Description ....................................... 1-3
2. Replacement of Main Parts
2-1.
CD-RW Drive Assembly ............................................................................ 2-1
2-2.
Replacement of Board ................................................................................. 2-1
2-2-1.
CS-42 Board ............................................................................... 2-1
2-2-2.
SW-42 Board .............................................................................. 2-2
2-2-3.
DK-42 Board .............................................................................. 2-2
2-2-4.
MD-42 Board ............................................................................. 2-3
2-2-5.
VS-42 Board ............................................................................... 2-4
2-2-6.
JD-42 Board ............................................................................... 2-4
2-2-7.
PE-42 Board ............................................................................... 2-5
2-2-8.
RM-42 Board ............................................................................. 2-5
2-3.
DC Fan ........................................................................................................ 2-6
2-4.
Switching Regulator .................................................................................... 2-6
2-5.
Mechanical Deck Assembly ........................................................................ 2-7
2-6.
PCMCIA Ejector ......................................................................................... 2-7
2-7.
Thermal Head .............................................................................................. 2-8
2-8.
Paper Feed Frame Assembly ....................................................................... 2-8
2-9.
Chassis Assembly ........................................................................................ 2-9
2-10. Stepping Motor ............................................................................................ 2-9
2-11. E Capstan Roller ....................................................................................... 2-10