background image
1
Ver 1.0 2003. 01
Model Name Using Similar Mechanism
NEW
CD Drive Mechanism Type
MG-930A-185
Optical Pick-up Name
OPTIMA-752B2
SERVICE MANUAL
US Model
Canadian Model
CDC-Z137
RADIO SECTION
(FM)
Frequency Range: 87.5 MHz ­ 108 MHz
Usable Sensitivity: 12.7 dBf
50 dB Quieting Sensitivity: 17.2 dBf
IF Rejection: 100 dB
Frequency Response: 30 Hz ­ 15,000 Hz
S/N Ratio: 70 dB
Stereo Separation: 35 dB at 1 kHz
Alternate Channel Selectivity: 90 dB
Capture Ratio: 3 dB
(AM)
Frequency Range: 530 kHz ­ 1,710 kHz
Usable Sensitivity: 30 µV (30 dB)
SPECIFICATIONS
CD SECTION
Frequency Response: 17 Hz ­ 20 kHz +0/­3 dB
Dynamic Range: More than 85 dB
Channel Separation: More than 60 dB
S/N Ratio: More than 90 dB
Wow/Flutter: Unmeasurable
AUDIO SECTION
Max. Power Output: 45 W
× 4 channels
AUX Input
Input sensitivity (load impedance) AUX: 300 mV (10 k
)
· The tuner and CD sections have no adjustments.
Sony Corporation
e Vehicle Company
Published by Sony Engineering Corporation
9-877-002-01
2003A0400-1
© 2003. 01
­ Continued on next page ­
FM/AM COMPACT DISC PLAYER


background image
2
CDC-Z137
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES
SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT.
NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES
SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL
OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
GENERAL
Power-Supply Voltage: 14.4 V (11 to 16 V allowable),
DC, negative ground
Load Impedance: 4
Tone Control: Bass ±10 dB at 100 Hz,
Treble ±10 dB at 10 kHz
Preamp Output Voltage (load impedance): 2.2 V (10 k
)
Installed size: 182 (W)
× 53 (H) × 155 (D) mm
(7 1/4 (W)
× 2 1/8 (H) × 6 1/8 (D) inches)
· Specifications and external appearance are subject
to change without notice due to product improvement.
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
· Never reuse a disconnected chip component.
· Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.


background image
3
TABLE OF CONTENTS
1. GENERAL
Connections ............................................................................. 4
2. DISASSEMBLY
2-1. Front Panel Assy ................................................................. 6
2-2. CD Mechanism Block ......................................................... 6
2-3. Cover ................................................................................... 7
2-4. Key Board ........................................................................... 7
2-5. Aux Board ........................................................................... 8
2-6. Removal The Solders .......................................................... 8
2-7. Main Board ......................................................................... 9
2-8. Heat Sink ............................................................................. 9
2-9. Sub Board .......................................................................... 10
2-10. Servo Board ....................................................................... 10
2-11. Floating Block Assy .......................................................... 11
2-12. Lever Assy (CD Up Holder) .............................................. 11
2-13. Lever (CD Roller) Sub Assy ............................................. 12
2-14. Lever Assy (CD Holder) ................................................... 12
2-15. Motor (Sled) Sub Assy ...................................................... 13
2-16. Pick-up Sub Assy .............................................................. 13
3. DIAGRAMS
3-1. IC Pin Descriptions ........................................................... 15
3-2. Block Diagram ­CD Section­ ........................................... 19
3-3. Block Diagram ­Main Section­ ........................................ 20
3-4. Block Diagram ­Front Section­ ........................................ 21
3-5. Circuit Boards Location .................................................... 21
3-6. Printed Wiring Boards ­CD Mechanism Section­ ............ 22
3-7. Schematic Diagram ­CD Mechanism Section­ ................ 24
3-8. Printed Wiring Boards ­Main Section­ ............................ 25
3-9. Schematic Diagram ­Main Section (1/2)­ ........................ 26
3-10. Schematic Diagram ­Main Section (2/2)­ ........................ 27
3-11. Printed Wiring Board ­Front Section­ .............................. 28
3-12. Schematic Diagram ­Front Section­ ................................ 29
3-13. IC Block Diagrams ............................................................ 30
4. EXPLODED VIEWS
4-1. Chassis Section ................................................................. 32
4-2. Front panel Section ........................................................... 33
4-3. CD Mechanism Section (1) ............................................... 34
4-4. CD Mechanism Section (2) ............................................... 35
5. ELECTRICAL PARTS LIST ........................................ 36
CDC-Z137


background image
4
CDC-Z137
SECTION 1
GENERAL
This section is extracted
from instruction manual.


background image
5
CDC-Z137
SECTION 2
DISASSEMBLY
Note : This set can be disassemble according to the following sequence.
2-1.
FRONT PANEL ASSY
(Page 6)
2-2.
CD MECHANISM BLOCK
(Page 6)
2-9.
SUB BOARD
(Page 10)
2-10. SERVO BOARD
(Page 10)
SET
2-16. PICK-UP SUB ASSY
(Page 13)
2-4.
KEY BOARD
(Page 7)
2-5.
AUX BOARD
(Page 8)
2-3.
COVER
(Page 7)
2-7.
MAIN BOARD
(Page 9)
2-8.
HEAT SINK
(Page 9)
2-6.
REMOVAL THE SOLDERS.
(Page 8)
2-11. FLOATING BLOCK ASSY
(Page 11)
2-12. LEVER ASSY (CD UP HOLDER)
(Page 11)
2-13. LEVER (CD ROLLER) SUB SSY
(Page 12)
2-14. LEVER ASSY (CD HOLDER)
(Page 12)
2-15. MOTOR (SLED) SUB ASSY
(Page 13)