background image
ORDER NO.
PIONEER CORPORATION 4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION 2002
RRV2653
DVD / CD RECEIVER
XV-DV303
T ­ ZZV JULY 2002 Printed in Japan
Type
Model
Power Requirement
Region No.
Remarks
XV-DV303
MYXJN
AC220-230V
2
NVXJN
AC230V
2
THIS MANUAL IS APPLICABLE TO THE FOLLOWING MODEL(S) AND TYPE(S).
OPEN/CLOSE
DVD/CD
FM/AM
DOWN
VOLUME
UP
STANDBY/ON
PHONES
6
0
TUNER
--
+
For details, refer to "Important symbols for good services" on the next page.


background image
2
1
23
4
12
3
4
C
D
F
A
B
E
XV-DV303
SAFETY INFORMATION
This service manual is intended for qualified service technicians ; it is not meant for the casual do-
it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trainedto properly and safely repair complex products such as those covered by this
manual.Improperly performed repairs can adversely affect the safety and reliability of the product
and mayvoid the warranty. If you are not qualified to perform the repair of this product properly and
safely, youshould not risk trying to do so and refer the repair to a qualified service technician.
WARNING !
THE AEL (ACCESSIBLE EMISSION LEVEL) OF THE LASER POWER OUTPUT IS LESS THAN CLASS 1
BUT THE LASER COMPONENT IS CAPABLE OF EMITTING RADIATION EXCEEDING THE LIMIT FOR
CLASS 1.
A SPECIALLY INSTRUCTED PERSON SHOULD DO SERVICING OPERATION OF THE APPARATUS.
LASER DIODE CHARACTERISTICS
FOR DVD : MAXIMUM OUTPUT POWER : 5 mW
WAVELENGTH : 650 nm
FOR CD :
MAXIMUM OUTPUT POWER : 5 mW
WAVELENGTH : 780 nm
Additional Laser Caution
: See page 78.
1. Laser Interlock Mechanism
· Loading switch (S101 on the LOAB Assy) is used for interlock
mechanism of the laser.
When this switch turned ON in SW2 (XCLOSE) side (OPEN signal is
0V and XCLOSE signal is 3.5V), a laser becomes the status which
can completely oscillate.
Furthermore, the laser completely oscillates in the disc judgment and
disc playback.
When player is power ON state and laser diode is not completely
oscillating, 780nm laser diode is always oscillating by half power.
· Laser diode is driving with Q101 (650nm LD) and Q102 (780nm LD)
on the DVDM Assy.
Therefore, when short-circuit between the emitter and collector of
these transistors or the base voltage is supplied for transistors turn
on, the laser oscillates. (failure mode)
· In the test mode
, there is the mode that the laser oscillates except
for the disc judgment and playback. LD ON mode in the test mode
oscillates with the laser forcibly.
The interlock mechanism mentioned above becomes invalid in this
mode.
2. When the cover is open, close viewing through the objective lens with
the naked eye will cause exposure to the laser beam.
Name Sheet
VRW1872


background image
3
1
23
4
1
2
3
4
C
D
F
A
B
E
XV-DV303
[ Important symbols for good services ]
In this manual, the symbols shown-below indicate that adjustments, settings or cleaning should be made securely.
When you find the procedures bearing any of the symbols, be sure to fulfill them:
2. Adjustments
To keep the original performances of the product, optimum adjustments or specification confirmation is indispensable.
In accordance with the procedures or instructions described in this manual, adjustments should be performed.
3. Cleaning
For optical pickups, tape-deck heads, lenses and mirrors used in projection monitors, and other parts requiring cleaning,
proper cleaning should be performed to restore their performances.
5. Lubricants, glues, and replacement parts
Appropriately applying grease or glue can maintain the product performances. But improper lubrication or applying
glue may lead to failures or troubles in the product. By following the instructions in this manual, be sure to apply the
prescribed grease or glue to proper portions by the appropriate amount.For replacement parts or tools, the prescribed
ones should be used.
4. Shipping mode and shipping screws
To protect the product from damages or failures that may be caused during transit, the shipping mode should be set or
the shipping screws should be installed before shipping out in accordance with this manual, if necessary.
1. Product safety
You should conform to the regulations governing the product (safety, radio and noise, and other regulations), and
should keep the safety during servicing by following the safety instructions described in this manual.


background image
4
1
23
4
12
3
4
C
D
F
A
B
E
XV-DV303
CONTENTS
SAFETY INFORMATION ...................................................................................................................................... 2
1. SPECIFICATIONS ............................................................................................................................................ 5
2. EXPLODED VIEWS AND PARTS LIST .......................................................................................................... 6
2.1 PACKING .................................................................................................................................................... 6
2.2 EXTERIOR SECTION ............................................................................................................................... 8
2.3 FRONT SECTION ................................................................................................................................... 10
2.4 LOADING MECANISM ASSY ................................................................................................................. 12
2.5 TRAVERSE MECHANISM ASSY ........................................................................................................... 14
3. BLOCK DIAGRAM AND SCHEMATIC DIAGRAM ........................................................................................ 16
3.1 BLOCK DIAGRAM ................................................................................................................................... 16
3.2 LOAB ASSY and OVERALL WIRING DIAGRAM ................................................................................... 18
3.3 DVDM ASSY 1/2 ..................................................................................................................................... 20
3.4 DVDM ASSY 2/2 ..................................................................................................................................... 22
3.5 DVD IF ASSY .......................................................................................................................................... 24
3.6 DSP ASSY ............................................................................................................................................... 26
3.7 FM/AM TUNER MODULE ....................................................................................................................... 28
3.8 AMP ASSY .............................................................................................................................................. 30
3.9 CONTROL ASSY 1/3, TRADE2 and TRADE3 ASSYS .......................................................................... 32
3.10 CONTROL ASSY 2/3 ............................................................................................................................ 34
3.11 CONTROL ASSY 3/3 ............................................................................................................................ 36
3.12 POWER ASSY 1/2 ................................................................................................................................ 38
3.13 POWER ASSY 2/2 and TRADE1 ASSY ............................................................................................... 40
3.14 DISPLAY and HP ASSYS ..................................................................................................................... 42
3.15 WAVEFORMS ....................................................................................................................................... 44
4. PCB CONNECTION DIAGRAM ..................................................................................................................... 45
4.1 LOAB ASSY ............................................................................................................................................ 45
4.2 DVDM ASSY ........................................................................................................................................... 46
4.3 DVD IF ASSY .......................................................................................................................................... 50
4.4 DSP ASSY ............................................................................................................................................... 52
4.5 FM/AM TUNER MODULE ....................................................................................................................... 54
4.6 DISPLAY and HP ASSYS ....................................................................................................................... 55
4.7 AMP ASSY .............................................................................................................................................. 56
4.8 CONTROL, TRADE2 and TRADE3 ASSYS ........................................................................................... 58
4.9 POWER and TRADE1 ASSYS ............................................................................................................... 62
5. PCB PARTS LIST .......................................................................................................................................... 66
6. ADJUSTMENT ............................................................................................................................................... 72
7. GENERAL INFORMATION ............................................................................................................................ 78
7.1 DIAGNOSIS ............................................................................................................................................. 78
7.1.1 TEST MODE .................................................................................................................................... 78
7.1.2 DISPLAY OF THE MECHANISM ERROR HISTORY ..................................................................... 84
7.1.3 TROUBLE SHOOTING .................................................................................................................... 87
7.1.4 SEQUENCE AFTER POWER ON ...................................................................................................89
7.1.5 PROTECTION CIRCUIT .................................................................................................................. 92
7.1.6 DISASSEMBLY ................................................................................................................................ 94
7.2 IC ............................................................................................................................................................. 99
7.3 CLEANING ............................................................................................................................................ 118
8. PANEL FACILITIES ..................................................................................................................................... 119


background image
5
1
23
4
1
2
3
4
C
D
F
A
B
E
XV-DV303
Accessories
· Power cord
(MYXJN : ADG1154)
· FM Antenna
(ADH7030)
· Power cord
(NVXJN : ADG1156)
· AM Loop Antenna
(ATB7009)
· Video Cord
(L = 1.5m)(VDE1053)
· Remote Control Unit
(AXD7337)
· Dry Cell Battery
(R6P, AA)
Yellow
5
46
3
8
79
0
2
1
TEST TONE
PROGRAM
FOLDER
FOLDER
CH LEVEL
TIMER
DVD DISP
INPUT
SHIFT
CHANEL
VOLUME
DIMMER
TV CONTROL
REPEAT
RANDOM
CLEAR
ENTER
5.1ch DVD SURROUND SYSTEM
AXD7337
DVD
AUDIO SUBTITLE ANGLE
ZOOM
AUTO SURROUND ADVANCED
QUIET/
MIDNIGHT
TV
LINE
L1/L2
FM/AM
DVD/CD
STANDBY/ON
BASSMODE SYSTEMDISP MUTE
ROOM
SETUP
SYSTEM SETUP
DVD SETUP
TOP MENU
DVD MENU
RETURN
SOUND
MODE
ST
ST
TUNE
TUNE
VOLUME
ENTER
1. SPECIFICATIONS
Amplifier section
Continuous Power Output (RMS):
Front, center, surround ... 75 W per channel
(1 kHz, 10 % T.H.D., 6
)
Subwoofer75 W (100 Hz, 10 % T.H.D., 6
)
Continuous Power Output :
Front, center, surround ... 62 W per channel
(1 kHz, 1 % T.H.D., 6
)
Subwoofer . 62 W (100 Hz, 1 % T.H.D., 6
)
Disc section
Digital audio
characteristics ............. DVD fs: 96 kHz, 24-bit
Type ........ DVD system, video CD system and
compact disc digital audio system
Frequency response ............... 4 Hz to 44 kHz
FM tuner section
Frequency range .................... 87.5 ­ 108 MHz
Antenna ............................... 75
, unbalanced
AM tuner section
Frequency range
With 9 kHz step ........ 531 kHz to 1,602 kHz
With 10 kHz step ...... 530 kHz to 1,700 kHz
(not applicable to European model)
Antenna ..................................... Loop antenna
Miscellaneous
Power requirements
European model .. AC 220­230 V, 50/60 Hz
Power consumption
European model ............................... 195 W
Power consumption in standby
European model .............................. 0.39 W
Dimensions ... 360 (W) x 70 (H) x 393 (D) mm/
14-3/16 (W) x 2-3/4 (H) x 15-1/2 (D) in.
Weight ................................... 7.0 kg/15 lb 7 oz
Accessories (DVD/CD receiver)
Remote control ............................................. 1
AA/R6P dry cell batteries .............................. 2
Video cable (yellow plugs) ............................ 1
AM loop antenna ........................................... 1
FM antenna .................................................. 1
Power cord .................................................... 1
Warranty Card ............................................... 1
Operating instructions
Quick setup guide
Speaker System
Front and surround speakers
Enclosure .............. Closed-box bookshelf type
(magnetically shielded)
System .......................... 8.7 cm 1-way system
Speakers .............................. 8.7 cm cone type
Nominal impedance .................................. 6
Frequency range ................. 100 Hz to 20 kHz
Maximum Input Power ............................ 75 W
Dimensions ... 110 (W) x 155 (H) x 76 (D) mm/
4-5/16 (W) x 6-1/8 (H) x 3 (D) in.
Weight ................................. 0.75 kg/1 lb 10 oz
Center speaker
Enclosure .............. Closed-box bookshelf type
(magnetically shielded)
System .......................... 8.7 cm 1-way system
Speakers .............................. 8.7 cm cone type
Nominal impedance .................................. 6
Frequency range ................. 100 Hz to 20 kHz
Maximum Input Power ............................ 75 W
Dimensions ... 200 (W) x 110 (H) x 76 (D) mm/
7-7/8 (W) x 4-5/16 (H) x 3 (D) in.
Weight ................................... 0.8 kg/1 lb 12 oz
Subwoofer
Enclosure ...................... Bass-reflex floor type
(magnetically shielded)
System ........................... 16 cm 1-way system
Speaker ................................. 16 cm cone type
Nominal impedance .................................. 6
Frequency range .................. 30 Hz to 2.8 kHz
Maximum Input Power ............................ 75 W
Dimensions . 130 (W) x 360 (H) x 360 (D) mm/
5-1/8 (W) x 14-3/16 (H) x 14-3/16 (D) in.
Weight ................................... 4.0 kg/8 lb 13 oz
Accessories (Speaker system)
Speaker cords ............................................... 6
Non-slip pads .............................................. 24
· Specifications and design subject to
possible modification without notice,
due to improvements.