Simplified Remote Control Operation Guide
1. Confirm the brand of Product that you are
trying to control and write down the 3 digit
code
2. Press and hold the SOURCE POWER Key
3. While holding the SOURCE POWER Key enter
the 3 digit Code for the device
4. The Remote control will respond with the word
O.K (RC-R0816 Only) or ERROR. (Please Begin
from Step 1 if ERROR Shows)
5. Release the SOURCE POWER key
6. Select and press the button of the type of
Device that you have just input the code for in
the REMOTE MODE AREA...There are 6
Choices
7. Press and Hold the SOURCE POWER Key and
point the remote control at the device you are
programming
8. If the Unit turns OFF or ON, the code the you
have input is correct
9. If the Unit does not respond, please try another
code or use the remote controls Learning
Functions (RC-R0816 Only)
Simplified Remote Control Learning
Functions of your devices can be learned onto your
Kenwood remote control and is handy in the
following situations:
a. The remote control does not contain a code or
appropriate code to control your device
b. The Code that has been inputted has limited
functionality and you need to add functions to
the Kenwood remote control.
In either of these situations, please follow these
steps
1. Place the 2 remote controls on a table with the
Infra Red Transmitters pointed at each other
2. Press the LEARN Key
3. Select the input corresponding to the device
that you are programming ie. DVD
4. Select the key on the Kenwood Remote control
that you want to learn...IE. Play function of
your DVD Player
5. The Remote will say WAIT
6. Press the corresponding key of the devices
remote (Make sure that it is transmitting into
the front of the Kenwood Remote Control)
7. The Remote will say OK if the function is
learned. If the remote control says AGAIN,
please repeat STEP 6.
8. Continue to program other functions from your
devices remote onto the Kenwood remote
using Steps 1 Thru 8