LVT0855-001A
[J]
KD-LH1000
1000
D
SOUND
VOL
VOL
SOURCE
R
F
U
D
200W
ENGLISH
ESP
AÑOL
FRANÇAIS
CD RECEIVER
KD-LH1000
INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MANUEL D'INSTRUCTIONS
RECEPTOR CON CD
KD-LH1000
RECEPTEUR CD
KD-LH1000
For customer Use:
Enter below the Model No. and
Serial No. which are located on
the top or bottom of the cabinet.
Retain this information for future
reference.
Model No.
Serial No.
For installation and connections, refer to the separate manual.
Para la instalación y las conexiones, refiérase al manual separado.
Pour l'installation et les raccordements, se référer au manuel séparé.
· This unit is equipped with the display demonstration. To cancel it, see page 8.
· Esta unidad está equipada con demostración en la pantalla. Para cancelarla, consulte la página 8.
· Cet appareil est équipé d'une fonction de démonstration des affichages. Pour l'annuler, référez-
vous à la page 8.
CoverKD-LH1000[J]f.pm5
2/13/02, 3:27 PM
3
Errata / Errata / Errata
English
Page 24
Incorrect
Correct
Notes:
· When you try to assign a name to the 41st disc,
"Name Full" appears on the display. (In this
case, delete unwanted names before assignment.)
\
Notes:
· When you try to assign a name to the 41st disc,
you cannot ener the text entry mode (and will
hear a beep sound if "Beep" has been set to
"On": see page 24) (In this case, delete
unwanted names before assignment.)
Español
Pàgina 24
Incorrecto
Correcto
Notes:
· When you try to assign a name to the 41st disc,
"Name Full" appears on the display. (In this
case, delete unwanted names before assignment.)
\
Notes:
· When you try to assign a name to the 41st disc,
you cannot ener the text entry mode (and will
hear a beep sound if "Beep" has been set to
"On": see page 24) (In this case, delete
unwanted names before assignment.)
Français Page 24
Incorrect
Correct
Notes:
· When you try to assign a name to the 41st disc,
"Name Full" appears on the display. (In this
case, delete unwanted names before assignment.)
\
Notes:
· When you try to assign a name to the 41st disc,
you cannot ener the text entry mode (and will
hear a beep sound if "Beep" has been set to
"On": see page 24) (In this case, delete
unwanted names before assignment.)
LV43133-001A
Errata1000JREV
02.2.21, 0:46 PM
1
2
ENGLISH
INFORMATION (For U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT FOR LASER PRODUCTS
Precautions:
1. CLASS 1 LASER PRODUCT
2. CAUTION: Invisible laser radiation when open and interlock failed or defeated. Avoid direct
exposure to beam.
3. CAUTION: Do not open the top cover. There are no user-serviceable parts inside. Leave all
servicing to qualified service personnel.
4. CAUTION: This CD player uses invisible laser radiation, however, is equipped with safety switches
to prevent radiation emission when unloading CDs. It is dangerous to defeat the safety switches.
5. CAUTION: Use of controls, adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
How to reset your unit
After detaching the control panel, press the reset
button on the panel holder using a ball-point pen
or similar tool.
This will reset the built-in microcomputer.
Note:
Your preset adjustments--such as preset channels or
sound adjustments--will also be erased.
BEFORE USE
*For safety....
· Do not raise the volume level too much, as this will
block outside sounds, making driving dangerous.
· Stop the car before performing any complicated
operations.
*Temperature inside the car....
If you have parked the car for a long time in hot or
cold weather, wait until the temperature in the car
becomes normal before operating the unit.
EN02-06LH1000[J]f.pm5
02.2.15, 1:24 PM
2
3
ENGLISH
CONTENTS
Thank you for purchasing a JVC product. Please read all instructions carefully before operation,
to ensure your complete understanding and to obtain the best possible performance from the unit.
How to reset your unit ...............................
2
How to use the MODE (M) button ............
3
LOCATION OF THE BUTTONS ............
4
Control panel ...........................................
4
Remote controller ....................................
5
Preparing the remote controller .................
6
BASIC OPERATIONS ......................
7
Turning on the power ................................
7
Changing the display pattern ....................
8
Canceling the display demonstration .......
8
RADIO OPERATIONS ......................
9
Listening to the radio ................................
9
Storing stations in memory .......................
11
Tuning in to a preset station .....................
12
Changing the display information .............
13
CD OPERATIONS .......................... 14
Playing a CD ............................................
14
Locating a track or a particular portion
on a CD .................................................
15
Selecting CD playback modes ..................
15
Prohibiting CD ejection .............................
16
Changing the display information .............
17
SOUND ADJUSTMENTS .................. 18
Adjusting the sound .................................
18
Selecting preset sound modes
(iEQ: i-equalizer) ...................................
19
Storing your own sound adjustments .......
19
Activating the level meter ..........................
21
OTHER MAIN FUNCTIONS ............... 22
Changing the general settings (PSM) ......
22
Changing the display color .......................
25
Assigning names to the sources ..............
28
Detaching the control panel ......................
29
CD CHANGER OPERATIONS ............. 30
Playing CDs .............................................
30
Locating a track or a particular portion
on a CD .................................................
31
Selecting a disc .......................................
31
Selecting CD playback modes ..................
32
EXTERNAL COMPONENT OPERATIONS ... 34
Playing an external component ................
34
TROUBLESHOOTING ...................... 35
MAINTENANCE ............................ 36
Handling CDs ..........................................
36
SPECIFICATIONS .......................... 37
Caution:
If the temperature inside the car is below 0°C (32°F), the movement of source animation and text scroll
will be halted on the display to prevent the display from being blurred.
When the temperature increases, and the operating temperature is resumed, these functions will start
working again.
How to use the MODE (M) button:
If you press MODE (M), the unit goes into functions mode and the number buttons work as different
function buttons.
To use these buttons as number buttons again after pressing MODE (M), wait for 5 seconds
without pressing any number button until the functions mode is cleared.
· Pressing MODE (M) again also clears the functions mode.
EN02-06LH1000[J]f.pm5
02.2.15, 1:24 PM
3
4
ENGLISH
1
2 3
4
6
9
p
8
5
7
E
EQ
u
y
t
r
e
w
q
i o
200W
1000
D-
;
1
(standby/on/attenuator) button
2 SEL (select) button
3 Control dial
4 Display window
5 Number buttons
6
4
/
¢
buttons
7
5 (up) button
8
0 (eject) button
9
(down) button
p
(control panel release) button
q EQ (E) (equalizer) button
LOCATION OF THE BUTTONS
Control panel
w DISP (D) (display) button
· Also functions as SSM buttons when pressed
together with MODE (M) button.
e MODE (M) button
· Also functions as SSM buttons when pressed
together with DISP (D) (display) button.
r FM/AM button
t CD/CD-CH button
y MO (monaural) button
u INT (intro) button
i RPT (repeat) button
o RND (random) button
; Remote sensor
EN02-06LH1000[J]f.pm5
02.2.15, 1:25 PM
4