VIDEO CASSETTE PLAYER
WITH LINE RECORDING
Thank you for purchasing this JVC video cassette player. To ensure optimum performance of this
unit, please read this instruction manual thoroughly.
Only cassettes marked "VHS" can be used with this video cassette player.
Features .................................. 2
Automatic features.................. 2
Wireless remote control.......... 5
On screen display................... 6
Connections ........................... 6
Setting the video channel........ 8
Mode set................................. 9
Setting Of The Colour System
Select Buttons ....................... 10
Recording ............................. 13
B.E.S.T. picture system.......... 13
Editing .................................. 14
Specifications ....................... 16
HRP110.book Page 1 Tuesday, August 3, 2004 4:51 PM
3 system (PAL/MESECAM/NTSC)
NTSC playback (on PAL television)
RF output G/K switchable
Digital auto tracking
HQ (High Quality)
Auto playback function
Still and slow motion
B.E.S.T. (Biconditional Equalized Signal
Tracking) picture system
Auto power on
The video cassette player is automatically
turned on when the tape is inserted.
The video tape is automatically rewound
when the end of the tape is reached during
the play, recording or shuttle search forward
If the video cassette's safety tab has been
removed, playback will begin automatically
when the tape is inserted into the video
Power off eject
Even when the video cassette player's power
is off, pressing the eject button will turn the
power on and eject the tape. Once ejected,
the power will be turned off again
Auto head cleaning
When a tape is loaded or ejected the VCP
video head is cleaned automatically.
HRP110.book Page 2 Tuesday, August 3, 2004 4:51 PM
The rating plate and the safety caution are on the rear of the unit.
WARNING: DANGEROUS VOLTAGE INSIDE
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
When the equipment is installed in a cabinet or a shelf, make sure that it has sufficient space on
all sides to allow for ventilation (10 cm or more on both side, on top and at the rear.)
When discarding batteries, environmental problems must be considered and the local rules or
laws governing the disposal of these batteries must be followed strictly.
Failure to heed the following precautions may result in damage to the player, remote control
or video cassette player.
1DO NOT place the player ...
...in an environment prone to extreme temperatures or humidity.
...in direct sunlight.
...in a dusty environment.
...in an environment where strong magnetic fields are generated.
...on a surface that is unstable or subject to vibration.
2DO NOT block the player's ventilation openings or holes.
(If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may
not be able to get out.)
3DO NOT place heavy objects on the player or remote control.
4DO NOT place anything which might spill on top of the player or remote control.
If water or liquid is allowed to enter this equipment, fire or electric shock may be caused.
5DO NOT expose the apparatus to dripping or splashing.
6DO NOT use this equipment in a bathroom or places with water. Also DO NOT place any
containers filled with water or liquids (such as cosmetics or medicines, flower vases, potted
plants, cups, etc.) on top of this unit.
7DO NOT place any naked flame sources, such as lighted candles, on the apparatus.
8 AVOID violent shocks to the player during transport.
Beware of moisture condensation
Moisture in the air will condense on the VCP when you move it from a cold place to a warm place, or
under extremely humid conditions --just as water droplets form on the surface of a glass filled with
cold liquid. Moisture condensation on the head drum will cause damage to the tape. In conditions
where condensation may occur, keep the VCP's power turned on for a few hours to let the moisture dry.
8 Be sure to remove cassette from VCP before packing.
8 Avoid violent shocks to the VCP during packing and transport.
1 button does not completely shut off mains power from the unit, but switches
operating current on and off.
This unit is produced to comply with Standard IEC 60065.
The socket outlet shall be installed near the equipment and easily accessible, or the mains
plug or an appliance coupler shall remain readily operable.
(For HR-P110AS only)
Use the conversion plug depending on the type of your AC wall outlet.
HRP110.book Page 3 Tuesday, August 3, 2004 4:51 PM
A SP/LP/EP button
To select the recording tape speed.
B Cassette loading slot
Load the video cassette here.
C 7 Record button
To start recording.
# Play button
To start playback.
¤ Stop/Eject button
To stop playback and to eject the video
Á Fast forward button
To fast forward the video tape and to start
forward shuttle search playback mode.
1 Rewind button
To rewind the video tape and to start
reverse shuttle search playback mode.
H Remote sensor window
For remote control operation.
I STANDBY/REC indicator
· Lights when the power turns off
(Standby mode) or during recording
· Blinks during recording pause mode.
J POWER-ON indicator
Lights when the power turns on.
K COLOUR SYSTEM button
To set the colour system for recording
and playback (
L 1 button
To turn the power on and off (standby
A AC power cord
B RF OUT terminal
C AUDIO/VIDEO IN terminals
D AUDIO/VIDEO OUT terminals
E ANT. IN terminal
HRP110.book Page 4 Tuesday, August 3, 2004 4:51 PM
Wireless remote control
Wireless remote control
When using the remote control for operation of the video cassette player, make sure that it is pointed at the
remote sensor window.
You can also use the player's remote control to operate a JVC television.
A Transmitting window
B 1 button
To turn the power on and off (standby).
C 9 PAUSE button
To freeze the picture during playback.
Also to engage the recording pause
To rewind the video tape. Also to start
reverse shuttle search playback.
E 7 REC button
7 REC to start recording.
F AUTO button
To enable/disable auto tracking mode.
· To select the recording tape speed.
· To select JVC TV's sounds.
G R/T buttons
To select the mode.
To set the mode.
H MENU button
To access Mode Set screen.
To start playback.
To fast forward the video tape. Also to
start forward shuttle search playback.
K 8 button
To stop playback.
L 0000 button
To reset the tape counter.
0 EJECT button
0 to eject the cassette. You also
can eject the cassette when the player is
N TRACKING +/ buttons
To adjust tracking during playback.
O OK/ button
· To fix the setting.
· To display the information on the
Point the remote control toward the
remote sensor window.
The maximum operating distance of the
remote control is about 8 m.
When inserting the batteries, be sure to
insert in the correct directions as indicated
under the battery cover.
If the remote control doesn't work
properly, remove its batteries, wait a short
time, replace the batteries and then try
HRP110.book Page 5 Tuesday, August 3, 2004 4:51 PM