background image
COMPACT COMPONENT SYSTEM
EX-A10
Consists of RX-EXA10, SP-EXA10 and XV-EXA10
LVT1403-002B
[J, C, UJ]
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
English
EXA10[J_C_UJ]-00Cov1.fm Page 1 Wednesday, October 17, 2007 4:19 PM


background image
G-1
(For U.S.A.)
(For U.S.A.)
(For U.S.A.)
(For U.S.A.)
The lightning flash with arrowhead symbol, within
an equilateral triangle is intended to alert the
user to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Section 820-40 of the NEC which provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable entry as practical.
Warnings, cautions and others
EXA10[J_C_UJ]-00Cov2.fm Page 1 Tuesday, September 13, 2005 12:51 PM


background image
G-2
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1. Do not remove screws, covers or cabinet.
2. Do not expose this appliance to rain or moisture.
ATTENTION
Afin d'éviter tout risque d'électrocution, d'incendie, etc.:
1. Ne pas enlever les vis ni les panneaux et ne pas ouvrir le cof-
fret de l'appareil.
2. Ne pas exposer l'appareil à la pluie ni à l'humidité.
CAUTION -- F button!
Disconnect the mains plug to shut the power off completely (the
STANDBY lamp goes off).
The F button in any position does not disconnect the mains
line.
· When the system is on standby, the STANDBY lamp lights
red.
· When the system is turned on, the STANDBY lamp goes off.
The power can be remote controlled.
ATTENTION - Touche F!
Déconnectez la fiche d'alimentation secteur pour couper l'ali-
mentation complètement (le témoin STANDBY s'éteint).
La touche F, dans n'importe quelle position, ne déconnecte
pas le système du secteur.
· Quand le système est en attente, le témoin STANDBY est
allumé en rouge.
· Quand le système est sous tension, le témoin STANDBY
s'éteint.
L'alimentation ne peut pas être télécommandée.
CAUTION
· Do not block the ventilation openings or holes.
(If the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able to get out.)
· Do not place any naked flame sources, such as lighted
candles, on the apparatus.
· When discarding batteries, environmental problems must be
considered and local rules or laws governing the disposal of
these batteries must be followed strictly.
· Do not expose this apparatus to rain, moisture, dripping or
splashing and that no objects filled with liquids, such as vases,
shall be placed on the apparatus.
ATTENTION
· Ne bloquez pas les orifices ou les trous de ventilation.
(Si les orifices ou les trous de ventilation sont bloqués par un
journal un tissu, etc., la chaleur peut ne pas être évacuée
correctement de l'appareil.)
· Ne placez aucune source de flamme nue, telle qu'une bougie,
sur l'appareil.
· Lors de la mise au rebut des piles, veuillez prendre en
considération les problèmes de l'environnement et suivre
strictement les règles et les lois locales sur la mise au rebut
des piles.
· N'exposez pas cet appareil à la pluie, à l'humidité, à un
égouttement ou à des éclaboussures et ne placez pas des
objets remplis de liquide, tels qu'un vase, sur l'appareil.
EXA10[J_C_UJ]-00Cov2.fm Page 2 Monday, September 12, 2005 6:16 PM


background image
G-3
(For U.S.A. or Canada models)
IMPORTANT FOR LASER PRODUCTS / IMPORTANT POUR PRODUITS LASER
(For models other than U.S.A. or Canada models)
IMPORTANT FOR LASER PRODUCTS / IMPORTANT POUR PRODUITS LASER
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the
unit; leave all servicing to qualified service personnel.
3. CAUTION: VISIBLE AND / OR INVISIBLE CLASS 1M LASER RADIATION WHEN
OPEN. DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL
INSTRUMENTS.
4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE THE UNIT.
1. PRODUIT LASER CLASSE 1
2. ATTENTION: N'ouvrez pas le couvercle supérieur. Il n'y a aucune pièce réparable par
l'utilisateur à l'intérieur de l'appareil; confiez toute réparation à un personnel qualifié.
3. ATTENTION: RAYONNEMENT LASER VISIBLE ET / OU INVISIBLE DE CLASSE 1M
UNE FOIS OUVERT. NE PAS FIXER LE FAISCEAU NI REGARDER DIRECTEMENT
AVEC DES INSTRUMENTS OPTIQUES.
4. REPRODUCTION DE L'ÉTIQUETTE: ÉTIQUETTE DE PRÉCAUTION PLACÉE À
L'INTERIEUR DE L'APPAREIL.
1. CLASS 1 LASER PRODUCT
2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the
unit; leave all servicing to qualified service personnel.
3. CAUTION: Visible and invisible laser radiation when open and interlock failed or
defeated. Avoid direct exposure to beam.
4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE THE UNIT.
1. PRODUIT LASER CLASSE 1
2. ATTENTION: N'ouvrez pas le couvercle supérieur. Il n'y a aucune pièce réparable par
l'utilisateur à l'intérieur de l'appareil; confiez toute réparation à un personnel qualifié.
3. ATTENTION: Risque de radiations laser visible et invisible quand l'appareil est ouvert et
que le système de verrouillage ne fonctionne pas ou a été mis hors service. Évitez toute
exposition directe au rayon.
4. REPRODUCTION DE L'ÉTIQUETTE: ÉTIQUETTE DE PRÉCAUTION PLACÉE À
L'INTERIEUR DE L'APPAREIL.
Warnings, cautions and others (continued)
EXA10[J_C_UJ]-00Cov2.fm Page 3 Wednesday, October 17, 2007 5:23 PM


background image
G-4
For Canada/pour le Canada
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE
DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND.
For Canada/pour le Canada
THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM
DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED
"DIGITAL APPARATUS", ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.
CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX
APPAREILS NUMIRIQUES DE CLASSE B PRESCRITES DANS LA NORME SUR LE MATERIEL BROUILLEUR:
"APPAREILS NUMERIQUES", NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS.
CAUTION -- Proper Ventilation
To avoid risk of electric shock and fire and to protect from damage, locate the apparatus as follows:
Top/Front/Back/Sides: No obstructions should be placed in the areas shown by the dimensions below.
Bottom:
Place on the level surface. Maintain adequate air path for ventilation by placing on
a stand with a height of 10 cm (3
) more.
In addition, maintain the best possible air circulation.
Attention: Ventilation correcte
Pour éviter tout risque d'électrocution et d'incendie, et pour ne pas endommager les appareils, placez-les
de la façon suivante:
Faces supérieure /avant / arrière / côtés : Aucune obstruction ne doit se trouver dans les zones
indiquées par les dimensions ci-dessous.
Bas :
Placez l'appareil sur une surface plane. Maintenez une entrée
d'air adéquate pour la ventilation en plaçant l'appareil sur un
support avec une hauteur d'au moins 10 cm (3
).
De plus, maintenez la meilleure circulation d'air possible.
15
16
15
16
Wall or
obstructions
Mur, ou
obstruction
Front
Avant
Front view
Side view
Vue avant
Vue de côté
15 cm (5
)
15
16
15 cm
(5
)
15
16
15 cm
(5
)
15
16
15 cm
(5
)
15
16
10 cm
(3
)
15
16
1 cm
(
)
7
16
1 cm
(
)
7
16
[European Union only]
[Union européenne seulement]
EXA10[J_C_UJ]-00Cov2.fm Page 4 Wednesday, October 17, 2007 4:20 PM