COPYRIGHT © 2001 VICTOR COMPANY OF JAPAN, LTD.
! SAFETY PRECAUTIONS
! MAIN DIFFERENCE PARTS LIST
! SPECIFIC SERVICE INSTRUCTIONS
! SERVICE ADJUSTMENTS
! PARTS LIST
STANDARD CIRCUIT DIAGRAM
Dimensions ( W×
TV RF System
CCIR ( I )
PAL / NTSC (Only in EXT mode)
NICAM ( I )
FLOF (Fastext)/WST(Word Standard system)
38.9MHz ( I )
Colour Sub Carrier Freq.
3.58MHz / 4.43MHz
AC 230V , 50Hz
172W(Max) / 121W(Avg),
Aerial Input Term
Visible size : 76cm, Measured diagonally
(at zero beam current)
20cm×4cm ,Oval type×2
7.5W + 7.5W
(Input / Output)
21-pin Euro connector
S / Video
1Vp-p 75(RCA pin jack)
500mVrms(-4dBs), High Impedance (RCA pin jack)
1Vp-p POSITIVE (Negative sync Provided, when
terminated with 75)
(Burst signal, when terminated with 75)
AUDIO OUT (Variable)
01Vrms, Low Impedance
(RCA pin jack×2)
Stereo mini jack (3.5mm )
Remote Control Unit
RM-C55 (AAA/R03 dry cell battery×2)
Design & specifications are subject to change without notice.
21-pin Euro connector (SCART socket) : EXT-1 / EXT-2 / EXT-3
(P-P= Peak to Peak, S-W= Sync tip to white peak, B-W= Blanking to white peak)
AUDIO R output
AUDIO R input
AUDIO L output
AUDIO L input
Low : 0-3V, High : 8-12V, High
R / C input
R : 700mV
C : 300mV
Low : 0 - 0.4, High : 1 - 3V, 75
P-P(Negative going sync), 75
VIDEO / Y input
P-P(Negative going sync), 75
The design of this product contains special hardware and many
circuits and components specially for safety purposes. For
continued protection, no changes should be made to the original
design unless authorized in writing by the manufacturer.
Replacement parts must be identical to those used in the original
circuits. Service should be performed by qualified personnel
Alterations of the design or circuitry of the product should not be
made. Any design alterations or additions will void the
manufacturer's warranty and will further relieve the manufacturer
of responsibility for personal injury or property damage resulting
Many electrical and mechanical parts in the product have special
safety-related characteristics. These characteristics are often not
evident from visual inspection nor can the protection afforded by
them necessary be obtained by using replacement components
rated for higher voltage, wattage, etc. Replacement parts which
have these special safety characteristics are identified in the
Parts List of Service Manual. Electrical components having such
features are identified by shading on the schematics and by (!)
on the Parts List in the Service Manual. The use of a substitute
characteristics as the recommended replacement part shown in
the Parts List of Service Manual may cause shock, fire, or other
The leads in the products are routed and dressed with ties,
clamps, tubing's, barriers and the like to be separated from live
parts, high temperature parts, moving parts and / or sharp edges
for the prevention of electric shock and fire hazard. When
service is required, the original lead routing and dress should be
observed, and it should be confirmed that they have been
returned to normal, after re-assembling.
The equipment has been designed and manufactured to meet international safety standards.
It is the legal responsibility of the repairer to ensure that these safety standards are maintained.
Repairs must be made in accordance with the relevant safety standards.
It is essential that safety critical components are replaced by approved parts.
If mains voltage selector is provided, check setting for local voltage.
" By preference, users can select the picture size from REGULAR,
PANORAMIC, FULL, 14:9 ZOOM, 16:9 ZOOM, 16:9 ZOOM SUB
TITLE modes. When the TV unit received WSS picture signal, the
picture can be changed to 16:9 ZOOM mode automatically.
" The TELETEXT SYSTEM has a built-in FASTEXT and WST
" Because this TV unit corresponds to multiplex broadcast, users
can enjoy music programs and sporting events with live realism.
In addition, BILINGUAL programs can be heard in their original
" Built-in ECO (ECONOMY, ECOLOGY) MODE.
In accordance with the brightness in a room, the brightness
and/or contrast of the picture can be adjusted automatically to
make the optimum picture which is easy on the eye.
" Users can make VCR dubbing of picture and sound by controlling
the AV selector to select an optional source at the EXT-2 output
shown in figure.
MAIN DIFFERENCE PARTS LIST
AV SEL. PWB
! RATING LABEL
! INST BOOK