background image
USER'S GUIDE ANALOG
q To set time
1) Pull the crown out when the second hand at 12 o'clock position
and the second hand stops.
2) Set the hands by turning the crown.
3) In accordance with a time signal, push the crown in.
Crown
50
40
30
20
10
Elapsed
time bezel
q For watch with the elapsed time bezel
Rotate the elapsed time bezel to align the
mark with the
minute hand.
After certain amount of time elapsed, read the graduation on the
elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
q For watch with a backlight
About the backlight
· Hold down L to illuminate the face of the watch.
· With Modules 1319 and 2312, pressing L illuminates the
display for about two or three seconds.
· With Modules 2342 and 2343, pressing L illuminates the
display for about one second.
· The backlight of this watch employs an electroluminescent (EL)
light, which loses its illuminating power after very long term use.
· Frequent use of the backlight shortens the battery life.
· Leaving the backlight on for a long time or turning on the
backlight while battery power is low can cause the hands of the
watch to stop momentarily.
q For watch with a screwlock crown
About the screwlock crown
· Some water resistant models are equipped with a screwlock
crown.
· With such models, you must unscrew the crown in the direction
noted in the illustration to loosen it before you can pull it out. Do
not pull too forcibly on such crowns.
· Also note that such watches are not water resistant while their
crowns are loosened. Be sure to screw the crowns back in as
far as they will go after making any setting.
qFor watch with a screwlock crown
To Set Time
1) Pull the crown out when the second click when the second
hand is at the 12 o'clock position and the second hand stops.
2) Turn the hands clockwise and put the watch four or five
minutes forward. Then back them out .
3) Push the crown in to the normal position on a time signal.
To Set Day-date
1) Pull the crown out to the first click.
2) Set the hands by turning the crown clockwise.
Set the date by turning the crown counterclockwise.
Check whether the day is English or Spanish.
3) Push the crown in to the nomal position.
Note:Avoid setting the day-date between 10:00 p.m. and 6:30 a.m.
(the day-date display may not change in the following day).
qFor watch with a date display
To Set Time
1) Pull the crown out to the second click when the second hand
is at the 12 o'clock position and the second hand stops.
2) Turn the hands clockwise and put the watch four or five
minutes forward. Then back them out .
3) In accordance with a time signal, push the crown in.
To Set Date
1) Pull the crown out to the first click.
2) Set the day by turning the crown clockwise.
3) Push the crown in to the nomal position.
Crown
Crown and
L (Light button)
Crown
30
30
SUN
L (Light button)
Crown (Normal position)
First click
(Setting date)
Second click
(Setting time)
Crown (Normal position)
First click
(Setting day-date)
Second click
(Setting time)
The configuration of your watch may differ
somewhat from that shown in the illustration
The configuration of your watch
may differ somewhat from that
shown in the illustration
[Day display]
SUN
MON
TUE
WED
THU
FRI
SAT
DOM
LUN
MAR
MIE
JUE
VIE
SAB
Spanish
English