background image
Operation Guide 1343/1794/2364
1
To Set Time and Date
· The configuration of your watch
may differ somewhat from that
shown in the illustration.
[Setting date]
1) Pull the crown out to the first
click.
2) Set the date by turning the
crown.
Avoid setting the date
between the hour of 8:00 p.m.
and 1:00 a.m. (The date
display may not change in the
following day).
3) Push the crown in to the
normal position.
[Setting time and day of the week]
1) Pull the crown out to the
second click when the second
hand is at 12 o'clock position
and the second hand stops.
2) Set the hands by turning the
crown. As you do, the day of
the week changes
accordingly.
· After setting day of the week,
carefully set the time, making
sure to distinguish between AM
and PM.
3) In accordance with a time
signal, push the crown in.
24-Hour Hand
The 24-Hour Hand indicates the
current hour of the day, making one
complete rotation every 24 hours.
Crown
(Normal position)
First click
(Setting date)
Second click
(Setting time and day
of the week)
Date
24-Hour Hand
Day of
the week
Crown
(Normal position)
First click
(Setting date)
Second click
(Setting time and day
of the week)
Date
24-Hour Hand
Day of
the week
[Module 1343/2364]
[Module 1794]
50
40
30
20
10
I For watch with the elapsed time bezel
Rotate the elapsed time bezel to align the
mark with the minute hand.
After certain amount of time elapsed, read the
graduation on the elapsed time bezel which
the minute hand points to.
The elapsed time is indicated.
Elapsed time bezel
· Some water resistant models are equipped
with a screw lock crown.
· With such models, you must unscrew the
crown in the direction noted in the illustration
to loosen it before you can pull it out. Do not
pull too forcibly on such crowns.
· Also note that such watches are not water
resistant while their crowns are loosened.
Be sure to screw the crowns back in as far
as they will go after making any setting.
MA0403-EA