QY8-1370-000
REVISION 0
COPYRIGHT
© 2000 CANON INC. CANON BJC-6200 0400 AB 0.20-0 PRINTED IN JAPAN (IMPRIME AU JAPON)
Apr. 2000
042000 AB 0.20-0
Application
This manual has been issued by Canon Inc. for qualified persons to learn technical theory, installation, maintenance, and repair
of products. This manual covers all localities where the products are sold. For this reason, there may be information in this
manual that does not apply to your locality.
Corrections
This manual could include technical inaccuracies or typographical errors due to improvements or changes in the products.
When changes occur in applicable products or in the content of this manual, Canon will release technical information as the
need arises. In the event of major changes in the contents of this manual over a long or short period, Canon will issue a new
editions of this manual
The following paragraph does not apply to any countries where such provisions are inconsistent with local
law.
Trademarks
The product names and company names described in this manual are the registered trademarks of the individual companies.
Copyright
This manual is copyrighted with all rights reserved. Under the copyright laws, this manual may not be copied, reproduced or
translated into another language, in whole or in part, without the written consent of Canon Inc., except in the case of internal
business use.
Copyright
2000 by Canon Inc.
CANON INC.
BJ Printer Technical Support Dept. 11
16-1, Shimonoge 3-chome, Takatsu-ku, Kawasaki, Kanagawa 213-8512, Japan
This manual has been produced on an Apple Power Macintosh 7300/180 personal computer and OKI MICROLINE 803 PSIIV
laser beam printer; artworks of printing films were printed on Agfa SelectSet Avantra 25. All page layouts, logos, and parts-list
data were saved with Canon Optical Disc Subsystem mo-5001STM and Optical Disc Cartridge mo-502MTM, and Interface Kit
mo-IF2TM for Macintosh. All graphics were produced with MACROMEDIA FREEHANDTM 7.0J. All documents and all page
layouts were created with QuarkXpressTM 3.3 Japanese version.
I
I. ABOUT THIS MANUAL
This manual consists of three parts containing information for servicing the product.
Part 1: Product Specifications
Product overview and specifications.
Part 2: Troubleshooting
A guide to troubleshooting the product and identifying the parts and units needing replacement.
Troubleshooting is described according to problem descriptions as well as error indications by the status
indicator.
Part 3: Appendix
Block diagrams, information on the hardware technologies, and pin configurations.
Disassembly and reassembly procedures are not fully covered in this manual. Refer to the
separate Parts Catalog instead.
Pr
oduct
Specifications
T
roub
leshooting
Appendix